I tried the new bootxx and it works great on my pm7300
thanx a lot....

Now I use a promise udma/100 which works without problems...
The only thing is that it downgrades the transfermode (pio 4, udma/33)...
because of a crc error or read error...
(cannot post dmesg, because I am at work now)

I read somewhere that macppc had problems generation crc32 with i386 devices
(in this case it was a ethernet card) some time ago
does anybody know if this was fixed and if it may be related to my
problem???

Another notice I made is that my pm7300 is more stable now, it did not crash
after a few hours...
it compiled xfree86 and a kernel without freezing or segfault... 

But I still have this relocationerror 68 I mentioned in my last post...

Regards
Andreas

>I think this should change the booting large kernels issue. I've used an
>ofwboot made with these changes to netboot my Beige G3, and it's been
>fine. While my kernel is less than 5 MB big, the relocation didn't break
>anything.
>
>Someone please test bootxx too. Making a boot floppy should do that...

-- 
www: http://drewke.net / icq:175089452

+++ NEU bei GMX und erstmalig in Deutschland: TÜV-geprüfter Virenschutz +++
100% Virenerkennung nach Wildlist. Infos: http://www.gmx.net/virenschutz