In message <2045.209.134.140.43.1011507607.squirrel@www.raptor.net>,
Robert Schmid wrote:

>When I connect the drive, the system disk, which was at sd0 is suddenly at
>sd1 and the drive on the adaptec card is sd0.

It's a know problem whith OpenFirmware which scans busses in a diffenent
order than /boot. The same problem exists with MacOSX or LinuxPPC.

I don't know any other solution than Robert's one.

Perhaps an automount system like MacOSX will do, which doesn't care of
/dev/ order for the boot disk, since it remounts it by partion name
after bootstrap.

-- 
Xav
http://www.freetibet.org
http://www.tibet.fr/