Subject: ANS 500 install
To: None <port-macppc@netbsd.org>
From: Chris Atwood <chatwood2@mac.com>
List: port-macppc
Date: 01/10/2002 16:53:53
Hi,
I am trying to install 1.5.2 on an Apple Network Server 500. I have an
Apple tulip network card installed too.
Problems started when I could get a serial console to connect to ttya,
thus I could do nothing after boot and the internal video went blank.
So I followed the instructions on how to setup boot onto a PCI video
card, using a spare ATI Rage 128 pro I had. Now I can see the installer
boot messages, which is good.
Now I see that the installer boot is failing, I have gotten two
different error messages so far:
1st - these lines print out and repeat
>trap type 700 at 946380
>panic: trap
>dumpsys; TBD
>rebooting
2nd - 2 sets of repeated messages repeated very fast (very hard to
read), they were about IRQ address and SCSI bus resets or something.
Any ideas? Is this being caused by the Rage 128? or my old old IBM SCSI
drive on bus 1 (the only scsi device (not counting the CD-ROM) - btw the
CD is on buss 0 and the drive on bus 1, both have ID 0 (pretty sure
anyway))
Thanks
Chris Atwood