If the install was successful, then in Open Firmware:
	boot wd0
should work (I think).  I have a 6400 but due to several problems and a
lack of money, I haven't been able to install on it (yet).

On Wed, 25 Aug 1999, [iso-8859-1] John Moore wrote:

> Hi folks,
> 
> I've just installed NetBSD-1.4.1 on to a Mac 6400 using a serial
> console and everything seemed to go just fine.
> 
> My problem is that I don't know how to boot it.
> I'm a complete newbe to NetBSD. I've seen the FAQ on the Homepage but
> don't understand it. I've changed the openfirmware so that it no longer
> uses the serial console i.e. inputs from the keyboard and displays to
> the screen. This computer is using a 2 GB IDE Harddrive. If anyone has
> booted from a 6400 could you please tell me how you did it in very
> simple terms.
> 
> Yours Sincerly