I was hoping to install NetBSD on my PowerBook 165 as soon as I get a SCSI
cable to help with the install.  I wanted to see if I could even boot a
1.4.1 kernel so I grabbed the 1.4.1 generic kernel and Booter-1.11.4,
hooked up to a terminal for a serial console and it sort of booted.

So my question is really, how far should I get just booting a kernel when
I haven't done a complete install?  Ie, if I get as far as shown below
should I expect the system to work once fully installed?

Bootstrapping NetBSD/mac68k.
Getting mapping from MMU.
System RAM: 12582912 bytes in 3072 pages.
     Low = 0x0, high = 0xc00000
Checking for Internal Video get_mapping(): PB/IIvx (0x60?00000).  False
start.
Done.
Bootstrapping the pmap system.
Pmap bootstrapped.
Moving ROMBase from 0x40800000 to 0x9f0000.
Video address 0x60040000 -> 0xbf0000.
[ preserving 359922 bytes of netbsd a.out symbol table ]
Copyright (c) 1996, 1997, 1998, 1999
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.
 
NetBSD 1.4.1 (GENERIC) #0: Wed Aug 11 04:56:57 CDT 1999
    fredb@corwin.home:/usr/src/sys/arch/mac68k/compile/GENERIC
Apple Macintosh PowerBook 165  (68030)
cpu: delay factor 355
real mem = 12582912
avail mem = 8429568
using 179 buffers containing 733184 bytes of memory
mrg: kernel has no ROM vectors for this machine!
mainbus0 (root)
obio0 at mainbus0
adb0 at obio0

[then nothing else comes]

Thanks for any advice.

-Dan