>The output of the `dmesg' command would be helpful, here.
Sorry! My unix administration knowledge is close to zero, so you just
taught me a new command!

Here it is: (I probably should mention that I did a MAKEDEV grf*) - a shot
in the dark ;-)

NetBSD 1.2A (GENERIC) #21: Sat Nov  9 10:16:20 EST 1996
    briggs@puma:/u/home/briggs/netbsd/sys/arch/mac68k/compile/GENERIC
Apple Macintosh Quadra 840AV  (68040)
real mem = 25165824
avail mem = 21368832
using 204 buffers containing 835584 bytes of memory
mrg: 'Quadra AV ROMs' ROM glue, tracing off, debug off, silent traps
mrg: I/O map kludge for ROMs that use hardware addresses directly.
adb: bus subsystem
Got following HwCfgFlags: 0xfc00, 0x4900081f, 0x 300bf26, 0x  9393b8
mrg: setup_egret:
mrg: setup_egret: done.
\^H\^H\^H\^H\^H\^Hadb: mapped device (5) at 2
adb: 200 dpi mouse at 3
mainbus0 (root)
obio0 at mainbus0
adb0 at obio0 (ADB event device)
esp0 at obio0: address 0x83d000: NCR53C96 25Mhz, target 7
scsibus0 at esp0
sd0 at scsibus0 targ 0 lun 0: <QUANTUM, LPS540S, 590A> SCSI2 0/direct fixed
sd0: 516MB, 2740 cyl, 4 head, 96 sec, 512 bytes/sec
sd1 at scsibus0 targ 2 lun 0: <MICROP, 4110-09NB_Nov18b, TN0F> SCSI2
0/direct fixed
sd1: 1002MB, 2428 cyl, 9 head, 93 sec, 512 bytes/sec
cd0 at scsibus0 targ 3 lun 0: <SONY, CD-ROM CDU-8003A, 1.9a> SCSI2 5/cdrom
removable
zsc0 at obio0 chip type 0
zstty0 at zsc0 channel 0
zstty1 at zsc0 channel 1
fpu0 at obio0 (mc68040)
nubus0 at mainbus0
root on sd1a swap on sd1b
PRAM time does not appear to have been read correctly.
PRAM: 0x83da807e, macos_boottime: 0x3293533a.

Thanks
/hcb

---
Hans-Christian Becker (hcb@phc.chalmers.se)
Dept. of Physical Chemistry
Chalmers University of Technology
Sweden