This is a MIME message. If you are reading this text, you may want to 
consider changing to a mail reader or gateway that understands how to 
properly handle MIME multipart messages.

--=__Part587E2694.0__=
Content-Type: text/plain; charset=US-ASCII
Content-Transfer-Encoding: 7bit
Content-Disposition: inline

My mistake.  Forgot to adjust the mtu to be the same size.  ath0 had a
mtu of 2290, and I was trying to bridge with an mtu of 1500.

David

>>> "David Dudley" <DavidDu@cctexas.com> 11/9/2007 2:46 PM >>>
I'm trying to create a bridge device to bridge my wireless traffic
through to a network interface.

I've got a system with an Atheros wireless card, running hostapd. 
This
works fine.  Got my remote site running wpa_supplicant configured, and
I
can ping between them to my hearts content, I can do ssh across the
wireless channel to get to the remote system,... all is well up to
now.

On the access host (running NetBSD-current, and hostapd)
I do
"ifconfig bridge0 create", it works fine, and I've got my bridge.
I do
"brconfig bridge0 add sip0 add sip1 add sip2 up", and I've got three
network interfaces in the bridge and it's running.

Whenever I attempt to do
"brconfig bridge0 add ath0" I get an error message 'brconfig: add
ath0:
invalid argument'.  Is this an unsupported operation, or did I just
forget an option?

David Dudley

--=__Part587E2694.0__=
Content-Type: text/plain; name="David Dudley.vcf"
Content-Transfer-Encoding: quoted-printable
Content-Disposition: attachment; filename="David Dudley.vcf"

BEGIN:VCARD
VERSION:2.1
FN:David Dudley
TEL;WORK:880-3740
ORG:;MIS
TEL;PREF;FAX:880-3741
EMAIL;WORK;PREF;NGW:DavidDu@cctexas.com
N:Dudley;David
END:VCARD


--=__Part587E2694.0__=--