On Sat, Feb 25, 2006 at 05:13:30AM +1030, Berndt Josef Wulf wrote:
> This is not a problme. My custom kernel boots fine with fwohci enabled. I have 
> attached the dmesg.log of the system in question.
>  

fwohci0: interrupting at irq 9 
fwohci0: OHCI version 1.10 (ROM=0)
fwohci0: No. of Isochronous channels is 4. 
fwohci0: EUI64 42:4f:c0:00:1d:4a:34:38
fwohci0: Phy 1394a available S400, 2 ports.
fwohci0: Link S400, max_rec 2048 bytes.
ieee1394if0 at fwohci0: IEEE1394 bus
fwip0 at ieee1394if0: IP over IEEE1394
fwohci0: Initiate bus reset

At which point does it hang here with the Xen0 kernel ? With Xen0, does
it detect fwohci0 at IRQ 9 too ? What about other devices which are
at IRQ 9 here ?

-- 
Manuel Bouyer <bouyer@antioche.eu.org>
     NetBSD: 26 ans d'experience feront toujours la difference
--