Jason Thorpe wrote:

> Where are your PHYs?

Here's the messages again with PHYs.  This is the machine that used to
be "bigkev", that I'm sure I bugged you about when I first got it :-)

wm0 at pci3 dev 3 function 0: Intel i82545EM 1000BASE-T Ethernet, rev. 1
wm0: interrupting at irq 11
wm0: 64-bit 133MHz PCIX bus
wm0: 256 word (8 address bits) MicroWire EEPROM
wm0: Ethernet address 00:30:48:70:41:98
makphy0 at wm0 phy 1: Marvell 88E1011 Gigabit PHY, rev. 3
makphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto

wm1 at pci4 dev 2 function 0: Intel i82545EM 1000BASE-T Ethernet, rev. 1
wm1: interrupting at irq 11
wm1: 64-bit 100MHz PCIX bus
wm1: 256 word (8 address bits) MicroWire EEPROM
wm1: Ethernet address 00:07:e9:1f:c4:71
makphy1 at wm1 phy 1: Marvell 88E1011 Gigabit PHY, rev. 3
makphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto

Cheers,
Simon.
--
Simon Burge                            <simonb@wasabisystems.com>
NetBSD Support and Service:         http://www.wasabisystems.com/