On Tue, Jul 10, 2001 at 11:57:01PM +1000, dkwok wrote:
> I have built Raid10 with 4 ide drive connect to the ATA66 VIA bus. The raid set works ok when there was not much traffic. When I started using it more it had dma loss-interrupt. Eventually I replace it with 2 Highpoint ATA 100 hot rod card. Of course I have to recompile the kernel to hardwire the details of pciide and wd specification into the kernel. After recompilation of kernel I copy the revised kernel into the root raid set. I have checked all raid device they are all with parity repaired and in sync. But when I reboot and set boot from raid sets. I have the following error:
> 
> fsck :/dev/rraid1a: segmentation fault
> unknown error; help!
> init: /bin/sh on /etc/rc terminated abnormally going to single user mode 
> ...
> 
> /dev/rraid1a is the root raid set. I have checked it with autoconf turned off, It seems to be in good order. Can anyone give me a pointer.

Looks like something got corrupted. Are the other partitions OK ?
Did you try to rebuild a disk with more than one disk failed ?

--
Manuel Bouyer <bouyer@antioche.eu.org>
--