Hello again, is there no one out there who can help me?


-d



----- Original Message -----
From: "daniel sjöberg" <dsjoberg@largemedium.com>
To: <port-i386@netbsd.org>
Sent: Thursday, March 01, 2001 3:49 PM
Subject: Audio, Neomagic MagicMedia 256ZX


> Hi!
>
> I need help/hints with configuring my audio....
>
> The chipset is:
>
> Neomagic MagicMedia 256ZX
>
> wich is also used for graphics, which is working just fine :o), after some
> tweaking.
>
>
> The machine is:
>
> Dell Latitude CPiR 400GT
> 400mhz pentium II
> 256mb RAM
> 6gb hardrive
>
>
> Hope someone can help me or point out some url's
>
> My dmesg output is as follows:
>
>
>
> NetBSD 1.5 (MY_LAPTOP_2) #0: Wed Feb 28 15:10:50 CET 2001
>
>
dsjoberg@dsjoberg-lap.largemedium.com:/usr/src/sys/arch/i386/compile/MY_LAPT
> OP_2
> cpu0: Intel Pentium II (Celeron) (686-class)
> total memory = 255 MB
> avail memory = 233 MB
> using 3296 buffers containing 13184 KB of memory
> BIOS32 rev. 0 found at 0xffe90
> PCI BIOS rev. 2.1 found at 0xfc0ce
> pcibios: config mechanism [1][x], special cycles [x][x], last bus 1
> PCI IRQ Routing Table rev. 1.0 found at 0xfbd80, size 112 bytes (5
entries)
> PCI Interrupt Router at 000:07:0 (Intel 82371MX Mobile PCI I/O IDE
> Xcelerator (MPIIX))
> ------------------------------------------
>   device vendor product pin PIRQ IRQ stage
> ------------------------------------------
> 000:03:0 0x104c 0xac1c   A  0x03  11  0    already assigned
> 000:03:1 0x104c 0xac1c   A  0x03  11  0    already assigned
> 000:07:2 0x8086 0x7112   D  0x03  11  0    already assigned
> 001:00:0 0x10c8 0x0006   A  0x00  11  0    already assigned
> 001:00:1 0x10c8 0x8006   B  0x01   5  0    already assigned
> ------------------------------------------
> PCI bridge 0: primary 0, secondary 1, subordinate 1
> PCI bridge 1: primary 0, secondary 2, subordinate 2
> PCI bridge 2: primary 0, secondary 3, subordinate 3
> PCI bus #3 is the last bus
> [System BIOS Setting]-----------------------
>   device vendor product
>   register space address    size
> --------------------------------------------
> 000:00:0 0x8086 0x7190
>  10h mem  0xf0000000 0x04000000
>   [OK]
> 000:01:0 0x8086 0x7191
>   [OK]
> 000:03:0 0x104c 0xac1c
>  10h mem  0x00000000 0x00001000
>   [NG]
> 000:03:1 0x104c 0xac1c
>  10h mem  0x00000000 0x00001000
>   [NG]
> 000:07:0 0x8086 0x7110
>   [OK]
> 000:07:1 0x8086 0x7111
>  20h port 0x00000860 0x00000010
>   [OK]
> 000:07:2 0x8086 0x7112
>  20h port 0x0000ece0 0x00000020
>   [OK]
> 000:07:3 0x8086 0x7113
>   [OK]
> 001:00:0 0x10c8 0x0006
>  10h mem  0xf6000000 0x02000000
>  14h mem  0xfdc00000 0x00400000
>  18h mem  0xfdb00000 0x00100000
>   [OK]
> 001:00:1 0x10c8 0x8006
>  10h mem  0xf5800000 0x00800000
>  14h mem  0xfda00000 0x00100000
>   [OK]
> --------------------------[  2 devices bogus]
>  Physical memory end: 0x0ffed000
>  PCI memory mapped I/O space start: 0x10000000
> [PCIBIOS fixup stage]-----------------------
>   device vendor product
>   register space address    size
> --------------------------------------------
> 000:00:0 0x8086 0x7190
>  10h mem  0xf0000000 0x04000000
>   [OK]
> 000:01:0 0x8086 0x7191
>   [OK]
> 000:03:0 0x104c 0xac1c
>  10h mem  0x10000000 0x00001000
>   [OK]
> 000:03:1 0x104c 0xac1c
>  10h mem  0x10001000 0x00001000
>   [OK]
> 000:07:0 0x8086 0x7110
>   [OK]
> 000:07:1 0x8086 0x7111
>  20h port 0x00000860 0x00000010
>   [OK]
> 000:07:2 0x8086 0x7112
>  20h port 0x0000ece0 0x00000020
>   [OK]
> 000:07:3 0x8086 0x7113
>   [OK]
> --------------------------[  0 devices bogus]
> mainbus0 (root)
> pnpbios0 at mainbus0: nodes 16, max len 276
> pnpbios0: not docked
> pci0 at mainbus0 bus 0: configuration mode 1
> pci0: i/o space, memory space enabled
> pchb0 at pci0 dev 0 function 0
> pchb0: Intel 82443BX Host Bridge/Controller (rev. 0x03)
> ppb0 at pci0 dev 1 function 0: Intel 82443BX AGP Interface (rev. 0x03)
> pci1 at ppb0 bus 1
> pci1: i/o space, memory space enabled
> vga1 at pci1 dev 0 function 0: Neomagic MagicMedia 256ZX VGA (rev. 0x00)
> wsdisplay0 at vga1: console (80x25, vt100 emulation)
> Neomagic MagicMedia 256ZX Audio (audio multimedia) at pci1 dev 0 function
1
> not configured
> cbb0 at pci0 dev 3 function 0: Texas Instruments PCI1225 PCI-CardBus
Bridge
> (rev. 0x01)
> cbb1 at pci0 dev 3 function 1: Texas Instruments PCI1225 PCI-CardBus
Bridge
> (rev. 0x01)
> pcib0 at pci0 dev 7 function 0
> pcib0: Intel 82371AB PCI-to-ISA Bridge (PIIX4) (rev. 0x02)
> pciide0 at pci0 dev 7 function 1: Intel 82371AB IDE controller (PIIX4)
(rev.
> 0x01)
> pciide0: bus-master DMA support present
> pciide0: primary channel wired to compatibility mode
> wd0 at pciide0 channel 0 drive 0: <IBM-DARA-206000>
> wd0: drive supports 16-sector pio transfers, lba addressing
> wd0: 5729 MB, 12416 cyl, 15 head, 63 sec, 512 bytes/sect x 11733120
sectors
> wd0: 32-bit data port
> wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 4
> pciide0: primary channel interrupting at irq 14
> wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2 (using DMA data
> transfers)
> pciide0: secondary channel wired to compatibility mode
> atapibus0 at pciide0 channel 1
> cd0 at atapibus0 drive 0: <TOSHIBA DVD-ROM SD-C2202, 6900004620, 1919>
type
> 5 cdrom removable
> cd0: 32-bit data port
> cd0: drive supports PIO mode 4, DMA mode 2
> pciide0: secondary channel interrupting at irq 15
> cd0(pciide0:1:0): using PIO mode 4, DMA mode 2 (using DMA data transfers)
> uhci0 at pci0 dev 7 function 2: Intel 82371AB USB Host Controller (PIIX4)
> (rev. 0x01)
> uhci0: interrupting at irq 11
> usb0 at uhci0: USB revision 1.0
> uhub0 at usb0
> uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
> uhub0: 2 ports with 2 removable, self powered
> Intel 82371AB Power Management Controller (PIIX4) (miscellaneous bridge,
> revision 0x02) at pci0 dev 7 function 3 not configured
> cbb0: interrupting at irq 11
> cbb0: cacheline 0x8 lattimer 0x20
> cbb0: bhlc 0x822008 lscp 0x20020200
> cardslot0 at cbb0 slot 0 flags 0
> cardbus0 at cardslot0: bus 2 device 0 cacheline 0x8, lattimer 0x20
> pcmcia0 at cardslot0
> cbb1: interrupting at irq 11
> cbb1: cacheline 0x8 lattimer 0x20
> cbb1: bhlc 0x822008 lscp 0x20030300
> cardslot1 at cbb1 slot 1 flags 0
> cardbus1 at cardslot1: bus 3 device 0 cacheline 0x8, lattimer 0x20
> pcmcia1 at cardslot1
> isa0 at pcib0
> com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
> com2 at isa0 port 0x3e8-0x3ef irq 5: ns16550a, working fifo
> pckbc0 at isa0 port 0x60-0x64
> pckbd0 at pckbc0 (kbd slot)
> pckbc0: using irq 1 for kbd slot
> wskbd0 at pckbd0: console keyboard, using wsdisplay0
> pmsi0 at pckbc0 (aux slot)
> pckbc0: using irq 12 for aux slot
> wsmouse0 at pmsi0 mux 0
> lpt0 at isa0 port 0x378-0x37b irq 7
> pcppi0 at isa0 port 0x61
> midi0 at pcppi0: PC speaker
> sysbeep0 at pcppi0
> isapnp0 at isa0 port 0x279: ISA Plug 'n Play device support
> npx0 at isa0 port 0xf0-0xff: using exception 16
> fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2
> isapnp0: no ISA Plug 'n Play devices found
> apm0 at mainbus0: Power Management spec V1.2
> biomask ef4d netmask ef4d ttymask ffcf
> ex0 at cardbus1 dev 0 function 0: 3Com 3c575B-TX Ethernet
> ex0: interrupting at 11
> ex0: MAC address 00:50:04:8c:7b:32
> ukphy0 at ex0 phy 0: Generic IEEE 802.3u media interface
> ukphy0: 78Q2120 10/100 media interface (OUI 0x00c039, model 0x0014), rev.
3
> ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
> boot device: wd0
> root on wd0a dumps on wd0b
> root file system type: ffs
> wsdisplay0: screen 1 added (80x25, vt100 emulation)
> wsdisplay0: screen 2 added (80x25, vt100 emulation)
> wsdisplay0: screen 3 added (80x25, vt100 emulation)
> wsdisplay0: screen 4 added (80x25, vt100 emulation)
> wsmux1: connecting to wsdisplay0
>
>