In message <4.3.2.7.2.20001217165925.02276548@3am-software.com>, Matt Thomas wr
ites:
>At 06:49 PM 12/17/2000 -0600, Peter Seebach wrote:
>>So, I have the option of trying to get this to work with either D-Link or
>>Linksys cards.  Both drivers find the card, claim they can't initialize it,
>>can't find a MAC address, and end up not configuring.  Anyone tried to make
>>this work?  Both cards are believed to be Intersil PRISIM II chipsets.
>
>dmesg output would be helpful.  But it sounds like there's not enough I/O
>space in the range assigned to the card.

Hmm.  There's 64k, or at least, the laptop is fine with a ray0.  :)  This
is a weird laptop which doesn't really have BIOS setup.  I'm using cardbus,
if it matters.

Here's my dmesg stuff.  This machine just supped earlier today, and I nuked
the compile directory before building.

The card info all looks consistent with the comments in if_wi.c, down
to the "01.02" version number.

Note that the two "wi0" probes you see in this output are from "different"
cards.  :)

NetBSD 1.5.1_ALPHA (GED) #0: Sun Dec 17 19:04:47 CST 2000
    root@ged.plethora.net:/usr/src/sys/arch/i386/compile/GED
cpu0: Intel Pentium II (Deschutes) (686-class)
total memory = 97728 KB
avail memory = 87700 KB
using 1247 buffers containing 4988 KB of memory
biostramp installed @ 1000
BIOS32 rev. 0 found at 0xfd820
PCI BIOS rev. 2.1 found at 0xfd880
pcibios: config mechanism [1][x], special cycles [1][x], last bus 0
PCI IRQ Routing Table rev. 1.0 found at 0xfafd0, size 96 bytes (4 entries)
PCI Interrupt Router at 000:06:0
PCI Exclusive IRQs: 11
------------------------------------------
  device vendor product pin PIRQ IRQ stage
------------------------------------------
000:02:0 0x104c 0xac16   A  0x00  11  0    already assigned
000:02:1 0x104c 0xac16   B  0x01  11  0    already assigned
000:03:0 0x10c8 0x0005   A  0x00  11  0    already assigned
000:06:2 0x8086 0x7112   D  0x03  11  0    already assigned
------------------------------------------
PCI bridge 0: primary 0, secondary 1, subordinate 1
PCI bridge 1: primary 0, secondary 2, subordinate 2
PCI bus #2 is the last bus
mainbus0 (root)
pnpbios0 at mainbus0: nodes 19, max len 329
pnpbios0: not docked
pckbc1 at pnpbios0 index 5 (PNP0303): kbd port
pckbc2 at pnpbios0 index 6 (IBM3781, attached as PNP0F13): aux port
pckbd0 at pckbc1 (kbd slot)
pckbc1: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard
pms0 at pckbc1 (aux slot)
pckbc1: using irq 12 for aux slot
wsmouse0 at pms0 mux 0
fdc1 at pnpbios0 index 8 (PNP0700)
fdc1: unable to map CTL I/O space
lpt0 at pnpbios0 index 11 (PNP0400)
lpt0: io 3bc-3bf, irq 7
com0 at pnpbios0 index 13 (PNP0501)
com0: io 3f8-3ff, irq 4
com0: ns16550a, working fifo
wss0 at pnpbios0 index 14 (CSC0000)
wss0: io 530-537 388-38b 220-233, irq 5, dma 1 0
wss0: CS4237B
audio0 at wss0: full duplex, mmap
opl0 at wss0: model OPL3
midi0 at opl0: WSS Yamaha OPL3
com1 at pnpbios0 index 19 (IBM0071, attached as PNP0511)
com1: io 2f8-2ff, irq 3, dma 3
com1: ns16550a, working fifo
pci0 at mainbus0 bus 0: configuration mode 1
pci0: i/o space, memory space enabled
pchb0 at pci0 dev 0 function 0
pchb0: Intel 82443BX Host Bridge/Controller (AGP disabled) (rev. 0x02)
cbb0 at pci0 dev 2 function 0: Texas Instruments PCI1250 PCI-CardBus Bridge (rev. 0x02)
cbb1 at pci0 dev 2 function 1: Texas Instruments PCI1250 PCI-CardBus Bridge (rev. 0x02)
vga0 at pci0 dev 3 function 0: Neomagic MagicMedia 256AV VGA (rev. 0x20)
wsdisplay0 at vga0: console (80x25, vt100 emulation), using wskbd0
pcib0 at pci0 dev 6 function 0
pcib0: Intel 82371AB PCI-to-ISA Bridge (PIIX4) (rev. 0x02)
pciide0 at pci0 dev 6 function 1: Intel 82371AB IDE controller (PIIX4) (rev. 0x01)
pciide0: bus-master DMA support present
pciide0: primary channel wired to compatibility mode
atapibus0 at pciide0 channel 0
cd0 at atapibus0 drive 1: <TOSHIBA CD-ROM XM-1702BC, \134377\134377\134377\134377, 1564> type 5 cdrom removable
cd0: 32-bit data port
cd0: drive supports PIO mode 4, DMA mode 2
wd0 at pciide0 channel 0 drive 0: <IBM-DADA-26480>
wd0: drive supports 16-sector pio transfers, lba addressing
wd0: 6194 MB, 13424 cyl, 15 head, 63 sec, 512 bytes/sect x 12685680 sectors
wd0: 32-bit data port
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 2
pciide0: primary channel interrupting at irq 14
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2 (using DMA data transfers)
cd0(pciide0:0:1): using PIO mode 4, DMA mode 2 (using DMA data transfers)
pciide0: secondary channel wired to compatibility mode
pciide0: secondary channel ignored (disabled)
uhci0 at pci0 dev 6 function 2: Intel 82371AB USB Host Controller (PIIX4) (rev. 0x01)
uhci0: interrupting at irq 11
usb0 at uhci0: USB revision 1.0
uhub0 at usb0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
Intel 82371AB Power Management Controller (PIIX4) (miscellaneous bridge, revision 0x02) at pci0 dev 6 function 3 not configured
cbb0: interrupting at irq 11
cbb0: cacheline 0x8 lattimer 0xb0
cbb0: bhlc 0x82a808 lscp 0xb0010100
cardslot0 at cbb0 slot 0 flags 0
cardbus0 at cardslot0: bus 1 device 0 cacheline 0x8, lattimer 0xb0
pcmcia0 at cardslot0
cbb1: interrupting at irq 11
cbb1: cacheline 0x8 lattimer 0xb0
cbb1: bhlc 0x82a808 lscp 0xb0020200
cardslot1 at cbb1 slot 1 flags 0
cardbus1 at cardslot1: bus 2 device 0 cacheline 0x8, lattimer 0xb0
pcmcia1 at cardslot1
isa0 at pcib0
pcppi0 at isa0 port 0x61
midi1 at pcppi0: PC speaker
spkr0 at pcppi0
sysbeep0 at pcppi0
npx0 at isa0 port 0xf0-0xff: using exception 16
apm0 at mainbus0: Power Management spec V1.2
apm: 1 batteries, global standby, global suspend, rtimer suspend, internal standby, pccard standby
biomask ef45 netmask ef45 ttymask ffc7
pcmcia0: CIS version PC Card Standard 5.0
pcmcia0: CIS info: Instant Wireless ,  Network PC CARD, Version 01.02, 
pcmcia0: Manufacturer code 0x156, product 0x2
pcmcia0: function 0: network adapter, ccr addr 3e0 mask 1
pcmcia0: function 0, config table entry 1: I/O card; irq mask ffff; iomask 6, iospace 0-3f; io16 irqpulse irqlevel
wi0 at pcmcia0 function 0wi0: init failed
: could not get mac address, attach failed
boot device: wd0
root on wd0a dumps on wd0b
init: copying out path `/sbin/init' 11
wsdisplay0: screen 1 added (80x25, vt100 emulation)
wsdisplay0: screen 2 added (80x25, vt100 emulation)
wsdisplay0: screen 3 added (80x50, vt100 emulation)
wsmux1: connecting to wsdisplay0
wi0 detached
pcmcia1: CIS version PC Card Standard 5.0
pcmcia1: CIS info: D, Link DWL-650 11Mbps WLAN Card, Version 01.02, 
pcmcia1: Manufacturer code 0x156, product 0x2
pcmcia1: function 0: network adapter, ccr addr 3e0 mask 1
pcmcia1: function 0, config table entry 1: I/O card; irq mask ffff; iomask 6, iospace 0-3f; io16 irqpulse irqlevel
wi0 at pcmcia1 function 0wi0: init failed
: could not get mac address, attach failed
wi0 detached
pcmcia1: CIS version PCMCIA 2.0 or 2.1
pcmcia1: CIS info: WebGear, PC Card WLAN Adapter, Version 4.88 Jan 1999
pcmcia1: Manufacturer code 0x1a6, product 0x0
pcmcia1: function 0: network adapter, ccr addr f00 mask b
pcmcia1: function 0, config table entry 1: I/O card; irq mask ffb8; memspace 0-bfff; mwait_required irqlevel
ray0 at pcmcia1 function 0: WebGear, PC Card WLAN Adapter, Version 4.88 Jan 1999
ray0: firmware version 85
ray0: 802.11 address 00:00:f1:11:5d:32
ray0 detached
pcmcia1: CIS version PCMCIA 2.0 or 2.1
pcmcia1: CIS info: WebGear, PC Card WLAN Adapter, Version 4.88 Jan 1999
pcmcia1: Manufacturer code 0x1a6, product 0x0
pcmcia1: function 0: network adapter, ccr addr f00 mask b
pcmcia1: function 0, config table entry 1: I/O card; irq mask ffb8; memspace 0-bfff; mwait_required irqlevel
ray0 at pcmcia1 function 0: WebGear, PC Card WLAN Adapter, Version 4.88 Jan 1999
ray0: firmware version 85
ray0: 802.11 address 00:00:f1:11:5d:32

-s