I just switched from a DPT Smartcache III to a Qlogic ISP1020
to run my CDR & 2 gig Seagate drive - the DPT card was blocking
too much airflow in the case, as it is a very long card.

On booting, I get the following message:
isp0 at pci0 dev 8 function 0
isp0: interrupting at irq 11
isp0: Board Revision 1020, loaded F/W Revision 4.65.0
isp0: Last F/W revision was 1.27.0
scsibus0 at isp0: 16 targets, 8 luns per target
.
.
.
scsibus0: waiting 2 seconds for devices to settle...
cd1 at scsibus0 target 1 lun 0: <, CRW620, 1.00> SCSI2 5/cdrom removable
sd0 at scsibus0 target 2 lun 0: <SEAGATE, ST32430N, 0346> SCSI2 0/direct
fixed
isp0: bus reset destroyed command for 0.2.0
isp0: timeout initiated SCSI bus reset of bus 0

sd0: 2047 MB, 3992 cyl, 9 head, 116 sec, 512 bytes/sect x 4194303 sectors


Is this bad?  This didn't happen with the DPT controller.
I'm running 1.5E.


Thanks,

Brian