Manuel Bouyer wrote:

> On Sun, Apr 16, 2000 at 01:03:42PM -0700, Segfault wrote:
>> Firmware messages:
>> 
>> DPT SCSI BIOS v003.DS
>> Controller: PM2044UM v07H.1 Port:E010H IRQ:12
>> Drive 1 ...
>> 
>> Boot-time messages:
>> DPT0 at pci0 dev9 function0
>> scsibus0 at dpt0 channel0 16 targets 8 lun
>> sd0 ...
>> 
>> Error messages:
>> sd0 (dpt:0:0:0) illegal request, data=00 00 00 00 24 00 00 ce 00 09
> 
> Would be interesting to have the SCSI command which caused this ...
> Could you edit scsipi_debug.h and add a:
> #define SCSIDEBUG
> 
> Also change DEBUGTYPE to BUS_SCSI and DEBUGTARGET to 0.
> 
> Then recompile a kernel and post messages here
> 
> --
> Manuel Bouyer, LIP6, Universite Paris VI.           Manuel.Bouyer@lip6.fr
> --

Well... That's a bit hard--considering I'm at the installation stage here.
All this time I'm booting from the install floppy, trying to install NetBSD
1.4.2.

Unfortunately, I only have SCSI drives (which are all connected to the DPT
adaptor). So, I couldn't recompile the kernel. :-(

I'll see about getting a small, dirt cheap IDE drive sometimes...

Lucas.