When I am trying to install 1.4.1 (using the boot.fs disk) on an system
configured much the same as shown below (2 more disks and 128M), I keep
getting:

uvm_fault (0xf041b0b8, 0xffeba000,0,1) -> 1
kernel: page fault trap, code, 0
Stopped in sysinst at 0xf01f5920: cmpb $0, 0xc0(%ebx)

right after the newfs is completed. I was having lockup problems under
1.3.3 on the same box when it was running squid (2.2STABLE4). I thought
the situation was similar to Richard Rauch's, but I was actually using
1.3.3.

Any thought or suggestions would be appreciated.




Copyright (c) 1996, 1997, 1998
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 1.3.3 (GENERIC) #0: Fri Dec 11 16:21:49 PST 1998
    root@struis:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: family 5 model 8 step c
cpu0: AMD K5 or K6 (586-class)
real mem  = 66650112
avail mem = 62775296
using 839 buffers containing 3436544 bytes of memory
mainbus0 (root)
pci0 at mainbus0 bus 0: configuration mode 1
VIA Technologies product 0x0598 (host bridge, revision 0x04) at pci0 dev 0
function 0 not configured
ppb0 at pci0 dev 1 function 0: VIA Technologies product 0x8598 (rev. 0x00)
pci1 at ppb0 bus 1
pcib0 at pci0 dev 7 function 0
pcib0: VIA Technologies VT82C586 (Apollo VP) PCI-ISA Bridge (rev. 0x47)
VIA Technologies product 0x0571 (IDE mass storage, interface 0x8a,
revision 0x06) at pci0 dev 7 function 1 not configured
VIA Technologies product 0x3040 (host bridge, revision 0x10) at pci0 dev 7
function 3 not configured
S3 Trio32/64 (VGA display, revision 0x54) at pci0 dev 9 function 0 not
configured
ahc1 at pci0 dev 10 function 0
ahc1: interrupting at irq 10
ahc1: aic7870 Single Channel, SCSI Id=7, 16 SCBs
scsibus0 at ahc1 channel 0: 8 targets
ahc1: target 0 synchronous at 10.0MHz, offset = 0xf
sd0 at scsibus0 targ 0 lun 0: <QUANTUM, FIREBALL_TM3200S, 300N> SCSI2
0/direct fixed
sd0: 3067MB, 6810 cyl, 5 head, 184 sec, 512 bytes/sect x 6281856 sectors
ahc1: target 1 synchronous at 10.0MHz, offset = 0xf
sd1 at scsibus0 targ 1 lun 0: <QUANTUM, FIREBALL_TM3200S, 300N> SCSI2
0/direct fixed
sd1: 3067MB, 6810 cyl, 5 head, 184 sec, 512 bytes/sect x 6281856 sectors
ep1 at pci0 dev 11 function 0: 3Com 3C905 Ethernet
ep1: MAC address 00:60:97:26:6d:d6
ep1: 8KB word-wide FIFO, (undefined) Rx:Tx split, mii default mii,
autoselect
ep1: interrupting at irq 12
isa0 at pcib0
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, working fifo
lpt0 at isa0 port 0x378-0x37b irq 7
npx0 at isa0 port 0xf0-0xff: using exception 16
pc0 at isa0 port 0x60-0x6f irq 1: color
pc0: console
fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB, 80 cyl, 2 head, 18 sec
biomask 440 netmask 1440 ttymask 14c2
boot device: sd0
root on sd0a dumps on sd0b
root file system type: ffs