Hi,

I added a new SCSI controller (Asus-SC860) to my system 
and now I cannot boot netbsd-1.3.2
Here is the kernel output:

ncr0 at pci0 dev 12 function 0: ncr 53c860 fast20 scsi
ncr0: interrupting at irq 11
ncr0: minsync=12, maxsync=137, maxoffs=8, 16 dwords burst, normal dma
fifo
ncr0: single-ended, open drain IRQ driver
ncr0: restart (scsi reset).
scsibus0 at ncr0: 8 targets
ncr0: aborting job...
ncr0:0: ERROR (10:0) (e-aa-0) (0/5) @ (script  104:c1000004)
ncr0: script cmd= c1000008
ncr0: regdump: da 10 80 05 47 00 00 1f 00 0e 00 aa 00 00 0a 00.
ncr0: have to clear fifos
ncr0: restart (fatal error).
probe(nrc0:0:0) COMMAND FAILED (9 ff) @0xf08afe00).

After this I just get lot of this messages even for SCSI-IDs where no
device
is attached.

ncr0: aborting job...
ncr0:0: ERROR (90:0) (8-a2-0) (0/5) @ (script  a0:43000060)
ncr0: script cmd= 878b0000
ncr0: regdump: da 00 05 47 00 01 1f 71 08 00 aa2 80 00 08 02.
ncr0: restart (fatal error).
probe(nrc0:0:0) COMMAND FAILED (9 ff) @0xf08afc00).

and so on.
My old controller from the other system (53c810) works perfectly.

Any ideas ?

Markus