Someone sent me a kernel to test.

  khym@dahan.metonymy.com was in the kernel config. Alas, I forgot who
it was that sent the kernel, and the above address bounces. I know you
read this list though :-)
  The results are appended below:

NetBSD 1.2G (SSW) #0: Mon Aug 18 20:53:59 CDT 1997
    khym@dahan.metonymy.com:/usr/src.local/sys/arch/i386/compile/SSW
cpu0: family 5 model 1 step 4
cpu0: AMD K5 (586-class)
real mem  = 33157120
avail mem = 29081600
using 430 buffers containing 1761280 bytes of memory
mainbus0 (root)
pci0 at mainbus0 bus 0: configuration mode 1
pchb0 at pci0 dev 0 function 0
pchb0: Intel 82430VX (Triton VX) Host Bridge (rev. 0x02)
pcib0 at pci0 dev 7 function 0
pcib0: Intel 82371SB (Triton II) PCI-ISA Bridge (rev. 0x01)
Intel 82371SB (Triton II) IDE controller (IDE mass storage, interface 0x80) at pci0 dev 7 function 1 not configured
Intel 82371SB (Triton II) USB Interface (USB serial bus, revision 0x01) at pci0 dev 7 function 2 not configured
Trident Microsystems TGUI 9660 (VGA display, revision 0xd3) at pci0 dev 17 function 0 not configured
ncr0 at pci0 dev 19 function 0: ncr 53c875 fast20 wide scsi
ncr0: interrupting at irq 10
ncr0: minsync=12, maxsync=137, maxoffs=16, 128 dwords burst, large dma fifo
ncr0: single-ended, open drain IRQ driver, using on-board RAM
ncr0: restart (scsi reset).
ncr0: copying script fragments into the on-board RAM ...
scsibus0 at ncr0: 16 targets
sd0 at scsibus0 targ 0 lun 0: <MICROP, 1588-15MBSUN0669, SN0C> SCSI1 0/direct fixed
sd0: 639MB, 1632 cyl, 15 head, 53 sec, 512 bytes/sect x 1309735 sectors
sd1 at scsibus0 targ 1 lun 0: <DEC, RZ28     (C) DEC, 442E> SCSI2 0/direct fixed
sd1: sd1(ncr0:1:0): WIDE SCSI (16 bit) enabled
sd1(ncr0:1:0): 20.0 MB/s (100 ns, offset 15)
2007MB, 3045 cyl, 16 head, 84 sec, 512 bytes/sect x 4110480 sectors
st0 at scsibus0 targ 6 lun 0: <ARCHIVE, Python 28849-XXX, 4.CM> SCSI2 1/sequential removable
st0: st0(ncr0:6:0): 5.0 MB/s (200 ns, offset 15)
density code 0x24, 512-byte blocks, write-enabled
ch0 at scsibus0 targ 6 lun 1: <ARCHIVE, Python 28849-XXX, 4.CM> SCSI2 8/changer removable
ch0: 4 slots, 1 drive, 1 picker, 0 portals
isa0 at pcib0
ep0 at isa0 port 0x280-0x28f irq 5: 3Com 3C509 Ethernet
ep0: MAC address 00:60:97:14:da:1d
ep0: 8KB byte-wide FIFO, 1:1 Rx:Tx split, utp/aui/bnc (default bnc)
ast0 at isa0 port 0x1a0-0x1bf irq 9
com2 at ast0 slave 0: st16650a, working fifo
com3 at ast0 slave 1: st16650a, working fifo
com4 at ast0 slave 2: st16650a, working fifo
com5 at ast0 slave 3: st16650a, working fifo
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, working fifo
lpt0 at isa0 port 0x378-0x37b irq 7
npx0 at isa0 port 0xf0-0xff: using exception 16
vt0 at isa0 port 0x60-0x6f irq 1
vt0: unknown trident, 80 col, color, 8 scr, mf2-kbd, [R3.32]
fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
biomask 440 netmask 460 ttymask 4e2
boot device: sd0
root on sd0a dumps on sd0b
root file system type: ffs
/dev/sd0a: file system not clean; please fsck(8)