Subject: 3c509B pnp or not
To: None <current-users@NetBSD.ORG>
From: Michael Richardson <mcr@sandelman.ottawa.on.ca>
List: port-i386
Date: 04/01/1997 10:17:56
-----BEGIN PGP SIGNED MESSAGE-----


  I installed my new system with -current.
  (I wound up getting a Symbios Ultra+Wide controller, so I needed
- -current. More expensive that I wanted, but I think it is worth
it. I'm still waiting for the ultra+wide drive. I installed on a old
639mb SCSI1 5.25" monster) 
  Perry: I did use the ssto-12C-970314b.fs image to install
with. Worked fine, except that I needed to ftp a kernel...

  I noticed that -current had ep* at isapnp0, so I enabled PNP on the
3c509B. (Bought this last Nov, in case this matters)

  I got:

Mar 31 13:40:24 istari /netbsd: ep0 at isa0 port 0x280-0x28f irq 5: 3Com 3C509 E
thernet
Mar 31 13:40:24 istari /netbsd: ep0: 1024KB word-wide FIFO, (undefined) Rx:Tx sp
lit,
Mar 31 13:40:24 istari /netbsd: ep0: erase pencil mark, or disable plug-n-play m
ode!
...
Mar 31 13:40:25 istari /netbsd: ep1 at isapnp0 port 0x210/16 irq 3
Mar 31 13:40:26 istari /netbsd: ep1: 3Com 3C509B EtherLink III
Mar 31 13:40:26 istari /netbsd: ep1: 8KB byte-wide FIFO, 1:1 Rx:Tx split, MAC ad
dress 00:60:97:14:da:1d

  I configured ep1 manually, and all seemed well... except that irq 3 
was already taken! I then rebooted, checked out the bios, made sure
that com2 was enabled, and not "auto"
 
  I then got:

Apr  1 02:57:41 istari /netbsd: ep0 at isa0 port 0x280-0x28f irq 5: 3Com 3C509 E
thernet
Apr  1 02:57:41 istari /netbsd: ep0: 8KB byte-wide FIFO, 1:1 Rx:Tx split, MAC ad
dress 00:60:97:14:da:1d

  i.e. no Plug and Play

  This morning I had some problems (unknown, syslogd was in state D,
and wouldn't die or do any logging), I rebooted and got:


Apr  1 02:53:31 istari /netbsd: ep0 at isa0 port 0x280-0x28f irq 5: 3Com 3C509 E
thernet
Apr  1 02:53:31 istari /netbsd: ep0: 1024KB word-wide FIFO, (undefined) Rx:Tx sp
lit, 
Apr  1 02:53:31 istari /netbsd: ep0: erase pencil mark, or disable plug-n-play m
ode! 

Apr  1 02:53:31 istari /netbsd: com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, w
orking fifo

Apr  1 02:53:32 istari /netbsd: ep1 at isapnp0 port 0x210/16 irq 3
Apr  1 02:53:32 istari /netbsd: ep1: 3Com 3C509B EtherLink III
Apr  1 02:53:32 istari /netbsd: ep1: 8KB byte-wide FIFO, 1:1 Rx:Tx split, MAC ad
dress 00:60:97:14:da:1d

  I disabled pnp and am happy.

  I thought that I should report this experience.

  [it sure would be nice to have a utility to set the cmos time from
inside Unix...]

  My complete boot messages are:

NetBSD 1.2D (SSW) #0: Mon Mar 31 17:03:35 EST 1997
    mcr@lox.sandelman.ottawa.on.ca:/sandel/netbsd/src/sys/arch/i386/compile/SSW
cpu0: family 5 model 1 step 4
cpu0: AMD K5 (586-class)
real mem  = 33157120
avail mem = 28430336
using 430 buffers containing 1761280 bytes of memory
mainbus0 (root)
pci0 at mainbus0 bus 0: configuration mode 1
Intel 82430VX (Triton VX) Host Bridge (host bridge, revision 0x02) at pci0 dev 0 function 0 not configured
pcib0 at pci0 dev 7 function 0
pcib0: Intel 82371SB (Triton II) PCI-ISA Bridge (rev. 0x01)
Intel 82371SB (Triton II) IDE controller (IDE mass storage, interface 0x80) at pci0 dev 7 function 1 not configured
Intel 82371SB (Triton II) USB Interface (USB serial bus, revision 0x01) at pci0 dev 7 function 2 not configured
Trident Microsystems TGUI 9660 (VGA display, revision 0xd3) at pci0 dev 17 function 0 not configured
ncr0 at pci0 dev 19 function 0: NCR 53c875 Wide SCSI
ncr0: interrupting at irq 10
        initial value of SCNTL3 = 03, final = 13
ncr0: restart (scsi reset).
scsibus0 at ncr0: 16 targets
sd0 at scsibus0 targ 0 lun 0: <MICROP, 1588-15MBSUN0669, SN0C> SCSI1 0/direct fixed
sd0: 639MB, 1632 cyl, 15 head, 53 sec, 512 bytes/sec
isa0 at pcib0
ep0 at isa0 port 0x280-0x28f irq 5: 3Com 3C509 Ethernet
ep0: 8KB byte-wide FIFO, 1:1 Rx:Tx split, MAC address 00:60:97:14:da:1d
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, working fifo
lpt0 at isa0 port 0x378-0x37b irq 7
npx0 at isa0 port 0xf0-0xff: using exception 16
vt0 at isa0 port 0x60-0x6f irq 1: unknown trident, 80 col, color, 8 scr, mf2-kbd, [R3.32]
fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
apm0 at mainbus0: Power Management spec V1.1
APM power mgmt engage (device 1)
:power management disabled (1)
apm0: A/C state: on
apm0: battery charge state: no battery
biomask 440 netmask 460 ttymask 4fa
boot device: sd0
root on sd0a swap on sd0b
root file system type: ffs
  



  
-----BEGIN PGP SIGNATURE-----
Version: 2.6.3ia
Charset: latin1
Comment: Processed by Mailcrypt 3.4, an Emacs/PGP interface

iQB1AwUBM0El4qZpLyXYhL+BAQH0nQMAkAbVyAsoJu8s0TilPoJj560NR1k7TYKt
sqroh/tEZ8/H2ELHeaUm3xEyn25y8KRWgEjY2PNNTaRdZ5r7rWwUvjdYWCPnRpb/
xf3oLz+893oX7KENvwfiOhmZvuzrkqNM
=nyZz
-----END PGP SIGNATURE-----