I've been current with -current up till sup service had problems and I was
running with no troubles.  After sup was restored, I am no longer able to
boot the i386 kernels I compile.  I have the same config as before, and I
am running 1.1 just fine on my hp380.  I supped last three days ago (the
18th).  The i386 kernels don't get as far as single user mode.  The last
things I see are:

	root device eisa not configured
	root device pci not configured
	biomask 4040 netmask 400 ttymask 101a
	kernel: Protection fault trap.  code = 0
	Stopped at _cpu_switch+0xc1	mov %ax,%fs

Any ideas or suggestions would be greatly apreciated.  I can't get a
reasonable stack trace, the frame pointer is bad.

This is on a Gateway 2000 laptop with an Intel i486, IDE drive and 24 Meg
of memory.

Dave