Luke Mewburn writes:
> 
> > I have a pre-CTRL-A Adaptec SCSI adapter (I don't know the exact flavor, but
> > it does not respond to CTRL-A during boot).  Do I need Adaptec software to
> > configure the card -- specifically, turn off internal bus termination -- or
> > is it a dipswitch/jumper tweak?

You pull out the three black resistor packs right next to the internal
SCSI connector and then try to figure out where
to put them so you'll find them again when you need them.

-- 
Peter Dufault               Real Time Machine Control and Simulation
HD Associates, Inc.         Voice: 508 433 6936
dufault@hda.com             Fax:   508 433 5267