Hi
 I just installed netbsd1.5 on my 425, so far, so good.

It detected my DDS drive, but there is no /dev/st0 .
I noticed that the following is a comment in the makefile

                #
                # block devices don't work so don't make them


Is this something new? Any possible fixes?


NetBSD 1.5 (GENERIC) #8: Sun Nov 19 21:36:31 MET 2000
    he@isabel.runit.no:/usr/src/sys/arch/hp300/compile/GENERIC
HP 9000/425s (25MHz MC68040 CPU+MMU+FPU, 4k on-chip physical I/D caches)
cpu: delay divisor 30, mmuid 7
total memory = 32756 KB
avail memory = 27252 KB
using 435 buffers containing 1740 KB of memory
Parity detection enabled
hil1: US ASCII keyboard
mainbus0 (root)
intio0 at mainbus0
frodo0 at intio0 addr 0x41c000
dnkbd at frodo0 offset 0x0 not configured
apci0 at frodo0 offset 0x40: no fifo
apci1 at frodo0 offset 0x60: no fifo
dio0 at mainbus0: 98620C, 2 channels, 32 bit DMA
nhpib0 at dio0 scode 7 ipl 3: internal HP-IB
hpibbus0 at nhpib0
ppi0 at hpibbus0 slave 5 punit 0
dca0 at dio0 scode 9 ipl 5: working fifo
internal parallel at dio0 scode 12 not configured
oscsi0 at dio0 scode 14 ipl 4: 32 bit dma, async, scsi id 7
st0 at oscsi0 targ 3 lun 0: <HP, HP35450A      -A, BE00> (SCSI-2)
sd0 at oscsi0 targ 4 lun 0: <HP, 2213A, C023>
sd0: 1457 cylinders, 16 heads, 1296512 blocks, 512 bytes/block
sd1 at oscsi0 targ 6 lun 0: <HP, 2213A, C023>
sd1: 1457 cylinders, 16 heads, 1296512 blocks, 512 bytes/block
le0 at dio0 scode 21 ipl 5: address 08:00:09:13:b5:f9
le0: 8 receive buffers, 2 transmit buffers
dcm0 at dio0 scode 26 ipl 5
dcm1 at dio0 scode 27 ipl 5
dcm2 at dio0 scode 28 ipl 5
dcm3 at dio0 scode 29 ipl 5
topcat0 at dio0 scode 133: 1280 x 1024 256 color hi-res catseye display
grf0 at topcat0
ite0 at grf0: console
interrupt levels: bio = 4, net = 5, tty = 5
boot device: sd1
root on sd1a dumps on sd1b
WARNING: bad date in battery clock
root file system type: ffs