Hello,

I'm trying to install NetBSD on a HP 425t. And my problem is how to
disklabel my Rodime Ro 3000T correct, During the boot of
the kernel it says something like:

sd6 RODIME RO3000T 1216 c, 9 h, 410211 Blocks and 512 bytes/block

Must be a 205 MB scsi disk

Ok, so far so good... But disklabel wants to know a bit more:

What ......Default...My Entry

Bytes/sector     [0]   512
Sectors/track    [0]   337
Tracks/cylinder  [0]     1
Sectors/cylinder [0]   337
Cylinder         [0]  1216

But I'm not sure wether this will work or not. Were to get the 
tracks/cylinder?

My partition table:

   Offset      Size
a     338     34630
b   34968     62500
c       0    410211
d   97486    312725
e       0         0
f       0         0
g       0         0

Should this work, or did I make a big mistake??
Any hint/help would be fine!

thank you
Philipp