KIYOHARA Takashi wrote:
> Hi! Garrett,
>
>
> Our Static Bus Controller on OMSAL400 was configured by YAMON. However,
> I think that we should do this configuration. 
>   

I think it is quite reasonable to rely on YAMON to configure these
busses.  If the configuration is *not* done there, then it should be
done in the board dependent code.  I don't think it is reasonable to put
this logic in the "common" code, as each board my have very different
ideas of what the setup is.

    -- Garrett
> For instance, aupcmcia uses the setting of YAMON.  Should we configure by
> ourselves?
> For that case, I think that a common interface is necessary. 
>
> Please tell your idea.
> --
> kiyohara
>   


-- 
Garrett D'Amore, Principal Software Engineer
Tadpole Computer / Computing Technologies Division,
General Dynamics C4 Systems
http://www.tadpolecomputer.com/
Phone: 951 325-2134  Fax: 951 325-2191