Hi,

Congratulations to  Soren S. Jorvang and Len Burns for getting this early
Cobalt RAQ sorted out. Still sorting out minor details, but it looks very
good. We replaced the Quantum disk with an IBM 30 gig, nice upgrade.

Jeff Northon
www.sasquatch.com


Copyright (c) 1996, 1997, 1998, 1999, 2000
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 1.4Z (RAQ_EXP) #0: Sun Jun  4 17:03:05 PDT 2000
    admin@bush:/usr/src/sys/arch/cobalt/compile/RAQ_EXP
256 MB memory, 195 MB free, 52400 KB in 13100 buffers
mainbus0 (root)
com0 at mainbus0 addr 0x1c800000 level 3: ns16550a, working fifo
com0: consolecpu0 at mainbus0: QED RM5200 CPU Rev. 1.0 with built-in FPU
Rev. 1.0
cpu0: L1 cache: 16KB/32B instruction, 16KB/32B data, two way set
associative
cpu0: No L2 cache
gt0 at mainbus0 addr 0x14000000 level 0
pci0 at gt0
pci0: i/o space, memory space enabled, rd/line, wr/inv ok
pchb0 at pci0 dev 0 function 0: Galileo GT-64011 System Controller, rev 2
tlp0 at pci0 dev 7 function 0: DECchip 21143 Ethernet, pass 4.1
tlp0: interrupting at level 1
tlp0: Ethernet address 00:10:e0:00:18:66
lxtphy0 at tlp0 phy 1: LXT970 10/100 media interface, rev. 3
lxtphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
pcib0 at pci0 dev 9 function 0
pcib0: VIA Technologies VT82C586 (Apollo VP) PCI-ISA Bridge, rev 39
pciide0 at pci0 dev 9 function 1: VIA Technologies VT82C586A IDE
Controller (rev. 0x06)
pciide0: bus-master DMA support present
pciide0: primary channel configured to compatibility mode
wd0 at pciide0 channel 0 drive 0: <IBM-DTLA-307030>
wd0: drive supports 16-sector pio transfers, lba addressing
wd0: 29314 MB, 16383 cyl, 16 head, 63 sec, 512 bytes/sect x 60036480
sectors
wd0: 32-bit data port
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 5
pciide0: primary channel interrupting at irq 14
wd0(pciide0:0:0): using PIO mode 4
pciide0: secondary channel configured to compatibility mode
pciide0: secondary channel ignored (disabled)
VIA Technologies VT83C572 USB Controller (USB serial bus, revision
0x02) at pci0 dev 9 
function 2 not configured
byte 4012gt0 at mainbus0 addr 0x14000000 level 0
pci0 at gt0
pci0: i/o space, memory space enabled, rd/line, wr/inv ok
pchb0 at pci0 dev 0 function 0: Galileo GT-64011 System Controller, rev 2
tlp0 at pci0 dev 7 function 0: DECchip 21143 Ethernet, pass 4.1
tlp0: interrupting at level 1
tlp0: Ethernet address 00:10:e0:00:18:66
lxtphy0 at tlp0 phy 1: LXT970 10/100 media interface, rev. 3
lxtphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
pcib0 at pci0 dev 9 function 0
pcib0: VIA Technologies VT82C586 (Apollo VP) PCI-ISA Bridge, rev 39
pciide0 at pci0 dev 9 function 1: VIA Technologies VT82C586A IDE
Controller (rev. 0x06)
pciide0: bus-master DMA support present
pciide0: primary channel configured to compatibility mode
wd0 at pciide0 channel 0 drive 0: <IBM-DTLA-307030>
wd0: drive supports 16-sector pio transfers, lba addressing
wd0: 29314 MB, 16383 cyl, 16 head, 63 sec, 512 bytes/sect x 60036480
sectors
wd0: 32-bit data port
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 5
pciide0: primary channel interrupting at irq 14
wd0(pciide0:0:0): using PIO mode 4
pciide0: secondary channel configured to compatibility mode
pciide0: secondary channel ignored (disabled)
VIA Technologies VT83C572 USB Controller (USB serial bus, revision
0x02) at pci0 dev 9 
function 2 not configured
boot device: wd0
root on wd0a dumps on wd0b
root file system type: ffs
raq%