>I was wondering if anyone's found a good source for mounting brackets to
>mount a 2.5" drive in a SHARK.  I've got one rigged right now.  In case

I asked our machine shop to fab some nice brackets :) They were L
shaped brackets that were about 3/8 " wide made out of aluminum with
holes drilled for the drive on the long part and on the short part,
holes for mounting where the zip drive would go.  They work quite nice
and shouldn't be that hard to make.  The screw on the case are 4/40s.

-- 
Phil Nelson                    NetBSD: http://www.netbsd.org
e-mail: phil@cs.wwu.edu        !gifs: http://www.gnu.org/philosophy/gif.html
http://www.cs.wwu.edu/~phil