I am not sure. How to reset/ignore the firmware on the Image. There must be
a switch or jumper on the mother board or io board to clear it.
Any ideas on how to clear it ?

Prasad Nuli

-----Original Message-----
From: Noriyuki Soda [mailto:soda@sra.co.jp]
Sent: Tuesday, August 15, 2000 2:07 AM
To: pnuli@mediaone.net
Cc: port-arc@netbsd.org
Subject: Re: What is this NEC Image POST Message


> Error: Firware could not open StandradIn
> Error: Fid for Standradout device is not one

Perhaps console device setting of ARC firmware is incorrect?
Normally, it should be the following:
	CONSOLEIN=multi()key()keyboard()console()
	CONSOLEOUT=multi()video()monitor()console()

I'm not sure how to fix this...
Isn't there any way to reset/ignore firmware setting?
--
soda