Port-amiga archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]
NetBSD 3.1 Installation
Hi to all!
I`ve been using NetBSD on AMiGA since v1.6, and now I`ve encountered
problems trying to install the v3.1.
My h/w setup is an A4000 with CSPPC 060@50/604e@150, 128+16MB Fast/2MB Chip
RAM, IDE (mobo) 2,1GB Seagate HD & LG CDRW Drive, SCSI (CS-UW3) 4GB Fujitsu
HD, Video CV-3D & scandoubler, Eth X-Surf, ALGOR-USB.
The problem now: The scsi drive was added recently, my previews
installations were on the mobo IDE drive (wd0a), and the CDROM was
recognized as well.
I`ve added the SCSI HD, I partitioned the disk and I tried to do a clean 3.1
installation using the miniroot.fs (dumped to the swap partition -sd0b-
using the xstreamtodev utility). When the kernel boots the CDROM is not
recognized, while the 2 HDs are ok (wd0 & sd0 for IDE and SCSI
respectively).
I select the Kb, select install, proceed with installation (Y), and the
screen is flooded with the following message:
sd0(cbiiisc0:0:0:0): Check Condition on CDB: 0x2a 00 00 4d 00 hex 00 00 hex
00 {where hex, various numbers on each repeated line, e.g. d8/30/10/78}
SENSE KEY: Aborted Command
ASC/ASCQ: AS 0x47 ASCQ 0xa1
This message is repeaded various times, and floods the screen, not
permitting the installation messages to be read.
If I continue fastly selecting the installation options, at editing the
fstab, I select NO (I cannot edit while the screen is flooded), and I get
the "/install: cannot open /tmp/fstab: no such file" error.
Any suggestions welcome.
Cass
_________________________________________________________________
Express yourself instantly with MSN Messenger! Download today it's FREE!
http://messenger.msn.click-url.com/go/onm00200471ave/direct/01/
Home |
Main Index |
Thread Index |
Old Index