Hi to all!

I`ve been using NetBSD on AMiGA since v1.6, and now I`ve encountered 
problems trying to install the v3.1.
My h/w setup is an A4000 with CSPPC 060@50/604e@150, 128+16MB Fast/2MB Chip 
RAM, IDE (mobo) 2,1GB Seagate HD & LG CDRW Drive, SCSI (CS-UW3) 4GB Fujitsu 
HD, Video CV-3D & scandoubler, Eth X-Surf, ALGOR-USB.

The problem now: The scsi drive was added recently, my previews 
installations were on the mobo IDE drive (wd0a), and the CDROM was 
recognized as well.
I`ve added the SCSI HD, I partitioned the disk and I tried to do a clean 3.1 
installation using the miniroot.fs (dumped to the swap partition -sd0b- 
using the xstreamtodev utility). When the kernel boots the CDROM is not 
recognized, while the 2 HDs are ok (wd0 & sd0 for IDE and SCSI 
respectively).
I select the Kb, select install, proceed with installation (Y), and the 
screen is flooded with the following message:

sd0(cbiiisc0:0:0:0):  Check Condition on CDB: 0x2a 00 00 4d 00 hex 00 00 hex 
00 {where hex, various numbers on each repeated line, e.g. d8/30/10/78}
     SENSE KEY: Aborted Command
      ASC/ASCQ: AS 0x47 ASCQ 0xa1

This message is repeaded various times, and floods the screen, not 
permitting the installation messages to be read.
If I continue fastly selecting the installation options, at editing the 
fstab, I select NO (I cannot edit while the screen is flooded), and I get 
the "/install: cannot open /tmp/fstab: no such file" error.

Any suggestions welcome.
Cass

_________________________________________________________________
Express yourself instantly with MSN Messenger! Download today it's FREE! 
http://messenger.msn.click-url.com/go/onm00200471ave/direct/01/