Christophe Prevotaux wrote:
> A1200(10M RAM) + CSA 12 Gauges 


- does your bootloader tell you where it loads the kernel, before it switches
  to the "grey screen"? Please report the address.
- What loadbsd-version do you use?
- What is the output of showconfig?
- What devices have you connected to your machine?

also, according to http://www.amiga-hardware.com/csa12.html, there are
several variants:

> CSA 12 Gauge
> 
> Processor: 030@50Mhz or EC030@40Mhz, 030@40Mhz, 030@33Mhz
> FPU: Optional 50Mhz 68882 (Except EC030)
> MMU: Internal in full 030

Are you sure you have a model with full MMU? (That is, does it pass the
Enforcer test, or did you boot successfully an earlier NetBSD version?)

If yes, I suggest that you boot with a terminal connected to the serial port
using a null modem cable. Early console output will come at 9600 bps, 8bits,
no parity. This might happen if your graphic are not recognized for some
reason, or if the kernel crashes before having fully initialized the graphics.

Regards,
	Ignatios Souvatzis