> Hi,
> 	I've been away from my NetBSD setup for a while and just got back. I
> have 1.1 running on an A4000 with WarpEngine. Previously I had a
> Spectrum card and was able to run X11R6 fine at 800x600. Since then I
> upgraded to a CyberVision 64/3D and now I can't get X11R6 up anymore. I
> used readcvmonitor to generate a new monitor.txt file which I placed in
> /etc. I've tried different mode settings in the startup files but either
> way when I type startx I get an error that says "can't find screen."
> Have I overlooked something simple or do I need to upgrade NetBSD to
> 1.3?

If I were nasty, I'd say: read the INSTALL files of both releases, and compare 
the supported hardware sections :-)

You have two options:

- tell your Xserver to use only AGA, or only the Spectrum (if still installed)
- upgrade to NetBSD-1.3 + the NetBSD-1.3 X11 distribution.

Regards,
	-is