Subject: Re: API CS20 remote halt/reset
To: Stephen Jones <firstname.lastname@example.org>
From: Stephen Jones <email@example.com>
Date: 07/18/2004 00:21:28
On Jul 18, 2004, at 12:04 AM, Stephen Jones wrote:
> However, the technical reference manual refers to 'J32' which I've
> not found yet (page 16 of
> the tech ref) is stated to be the reset jumper 'accessible when the
> system cover is removed' .. Anyone had any luck?
J32 is indeed SW2 (though it is not labeled on the board). This was
sussed from the user's guide.
You might be able to cut a piece out of the grille behind that fan then
desolder the switch and install
a wire to run to your relay without too much fuss, just do it carefully.