Subject: tga_console problem trying to install 1.5.2
To: None <port-alpha@netbsd.org>
From: Ed Gould <ed@left.wing.org>
List: port-alpha
Date: 01/15/2002 00:17:59
I'm trying to install NetBSD 1.5.2 for the first time on an AlphaStation 
500/333, from floppies.  When the kernel on the floppy tries to boot, it 
panics immediately with:

	panic: tga_console(7, 0): unknown board configuration

Below is the boot-time output from the Digital UNIX 4.0F that's currently 
running on this machine.  Any thoughts?  (Note that there are two display 
cards, tga0 and tga1 in this machine.)

Alpha boot: available memory from 0x95c000 to 0x7f16000
Digital UNIX V4.0F  (Rev. 1229); Thu Dec  9 15:57:53 PST 1999 
physical memory = 128.00 megabytes.
available memory = 118.34 megabytes.
using 483 buffers containing 3.77 megabytes of memory
Firmware revision: 6.3
PALcode: Digital UNIX version 1.21
Digital AlphaStation 500/333
pci0 at nexus
tu0: DECchip 21040: Revision: 2.4
tu0 at pci0 slot 6
tu0: DEC TULIP (10Mbps) Ethernet Interface, hardware address: 00-00-F8-23-24-0C
tu0: console mode: selecting 10BaseT (UTP) port: half duplex
tga0 at pci0 slot 7
tga0: depth 32, map size 16MB, 1280x1024
tga0: ZLXp2-E, Revision: 34
tu1: DECchip 21140: Revision: 2.2
tu1: auto negotiation capable device
tu1 at pci0 slot 8
tu1: DEC TULIP (10/100) Ethernet Interface, hardware address: 00-00-F8-1A-4B-2B
tu1: auto negotiation on: will advertise 100BaseTX (UTP) port: full duplex
isp0 at pci0 slot 9
isp0: QLOGIC ISP1020A
isp0: Firmware revision 2.10 (loaded by console)
Testing of physical memory complete (0 pages bad).
scsi0 at isp0 slot 0
rz0 at scsi0 target 0 lun 0 (LID=0) (DEC     RZ28D    (C) DEC 0010) (Wide16)
rz4 at scsi0 target 4 lun 0 (LID=1) (DEC     RRD45   (C) DEC  0436)
eisa0 at pci0
ace0 at eisa0
ace1 at eisa0
lp0 at eisa0
fdi0 at eisa0
fd0 at fdi0 unit 0
tga1 at pci0 slot 12
tga1: depth 32, map size 16MB, 1280x1024
tga1: ZLXp2-E, Revision: 34
gpc0 at eisa0
kernel console: tga0
dli: configured
ADVFS: using 1150 buffers containing 8.98 megabytes of memory
vm_swap_init: warning /sbin/swapdefault swap device not found
vm_swap_init: swap is set to lazy (over commitment) mode
tu1: auto negotiation restart: will advertise 100BaseTX: full duplex
tu1: link up: negotiated 100BaseTX: full duplex
Environmental Monitoring Subsystem Configured.
SuperLAT. Copyright 1994 Meridian Technology Corp. All rights reserved.
tu1: link up: negotiated 100BaseTX: full duplex


	--Ed