--DXwI5bo5Pb
Content-Type: text/plain; charset=us-ascii
Content-Description: message body text
Content-Transfer-Encoding: 7bit

Hi!

Just tried to upgrade a Digital AlphaStation 500/500 from NetBSD 1.4.2
to the 1.5 snapshot. After reading both install disks the kernel
panics with something like:

  tga_console ...: unknown board configuration

Any hint? (Complete boot mesg under 1.4.2 attached)

Markus.


--DXwI5bo5Pb
Content-Type: text/plain
Content-Description: NetBSD 1.4.2/alpha boot mesg
Content-Disposition: inline;
	filename="bm"
Content-Transfer-Encoding: 7bit

Copyright (c) 1996, 1997, 1998, 1999, 2000
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 1.4.2A (DFGAXP) #1: Thu Jun 29 13:26:43 MEST 2000
    kilbi@dfgaxp:/usr/src/sys/arch/alpha/compile/DFGAXP
Digital AlphaStation 500/500, 500MHz
8192 byte page size, 1 processor.
real mem = 301989888 (2310144 reserved for PROM, 299679744 used by NetBSD)
avail mem = 259891200
using 3658 buffers containing 29966336 bytes of memory
mainbus0 (root)
cpu0 at mainbus0: ID 0 (primary), 21164A-0 ()
cia0 at mainbus0: DECchip 2117x Core Logic Chipset (ALCOR/ALCOR2), pass 3
cia0: extended capabilities: 21<DWEN,BWEN>
cia0: using BWX for PCI config access
pci0 at cia0 bus 0
pci0: i/o enabled, memory enabled
de0 at pci0 dev 6 function 0
de0: interrupting at kn20aa irq 13
de0: DEC 21040 [10Mb/s] pass 2.6
de0: address 00:00:f8:25:36:45
vga0 at pci0 dev 8 function 0: Digital Equipment TGA2 (rev. 0x22)
wsdisplay0 at vga0: console (80x25, vt100 emulation)
isp0 at pci0 dev 9 function 0
isp0: interrupting at kn20aa irq 12
isp0: Board Revision 1020A, loaded F/W Revision 4.65.0
isp0: Last F/W revision was 5.57.1
isp0: 243 max I/O commands supported
isp0: invalid NVRAM header (55,aa,cc,33)
isp0: driver initiated bus reset of bus 0
scsibus0 at isp0: 16 targets, 8 luns per target
sd0 at scsibus0 targ 0 lun 0: <IBM, DCAS-34330, S65A> SCSI2 0/direct fixed
sd0: 4134MB, 8205 cyl, 6 head, 171 sec, 512 bytes/sect x 8467200 sectors
sd1 at scsibus0 targ 2 lun 0: <FUJITSU, M2266S-512, 0020> SCSI1 0/direct fixed
sd1: 1028MB, 1656 cyl, 15 head, 84 sec, 512 bytes/sect x 2105922 sectors
isp0: Bus 0 Target 4 Async Mode
cd0 at scsibus0 targ 4 lun 0: <DEC, RRD46   (C) DEC, 0557> SCSI2 5/cdrom removable
isp0: Bus 0 Target 5 Async Mode
sd2 at scsibus0 targ 5 lun 0: <SEAGATE, ST32171N, 0484> SCSI2 0/direct fixed
sd2: 2062MB, 5172 cyl, 5 head, 163 sec, 512 bytes/sect x 4223444 sectors
pceb0 at pci0 dev 10 function 0: Intel 82375EB/SB PCI-EISA Bridge (PCEB) (rev. 0x15)
eisa at pceb0 not configured
isa0 at pceb0
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, working fifo
lpt0 at isa0 port 0x3bc-0x3bf irq 7
pckbc0 at isa0 port 0x60-0x64
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard
pms0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pms0
pcppi0 at isa0 port 0x61
spkr0 at pcppi0
isabeep0 at pcppi0
fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB, 80 cyl, 2 head, 18 sec
mcclock0 at isa0 port 0x70-0x71: mc146818 or compatible
wscons: wskbd0 glued to wsdisplay0 (console)
root on sd1a dumps on sd1b
root file system type: ffs
de0: enabling 10baseT port
isp0: Bus 0 Target 2 Async Mode, 16 bit wide, Tagged Queueing Enabled
isp0: Bus 0 Target 5 at 10MHz Max Offset 12, Tagged Queueing Enabled
isp0: Bus 0 Target 5 at 10MHz Max Offset 12, Tagged Queueing Enabled
isp0: Bus 0 Target 5 at 10MHz Max Offset 12, Tagged Queueing Enabled
isp0: Bus 0 Target 5 at 10MHz Max Offset 12, Tagged Queueing Enabled

--DXwI5bo5Pb--