I followed the direction on the web page for setting up the server, wich
is slackware linux running ISO dhcpd.

rpc.mountd
rpc.nfsd
dhcpd 

all aree running fine, here is a log of the events on the Alpha:
---begin capture---
>>> boot -flags a ez0
INIT-S-CPU...
INIT-S-RESET_TC...
INIT-S-ASIC...
INIT-S-MEM...
INIT-S-NVR...
INIT-S-SCC...
INIT-S-NI...
INIT-S-SCSI...
INIT-S-ISDN...
AUDIT_BOOT_STARTS ...
AUDIT_BOOT_REQ
Host server IP address is 208.223.124.17
AUDIT_BSERVER_FOUND


  84 FAIL

>>>

---end of capture---



and here is a log of tail -f /var/log/messages on the linux box:
---begin capture---
May 25 09:17:33 www dhcpd: Internet Software Consortium DHCP Server
V3.0b1pl13
May 25 09:17:33 www dhcpd: Copyright 1995, 1996, 1997, 1998, 1999 The
Internet Software Consortium.
May 25 09:17:33 www dhcpd: All rights reserved.
May 25 09:17:33 www dhcpd:  Please contribute if you find this software
useful.
May 25 09:17:33 www dhcpd: For info, please visit
http://www.isc.org/dhcp-contrib.html
May 25 09:17:33 www dhcpd: Listening on
LPF/eth0/00:a0:c9:6b:30:87/208.223.124.0
May 25 09:17:33 www dhcpd: Sending on  
LPF/eth0/00:a0:c9:6b:30:87/208.223.124.0
May 25 09:17:33 www dhcpd: Sending on   Socket/fallback/fallback-net
May 25 09:18:56 www dhcpd: BOOTREQUEST from 08:00:2b:be:da:dc via eth0
May 25 09:18:56 www dhcpd: BOOTREPLY for 208.223.124.252 to client
(08:00:2b:be:da:dc) via eth0
---end capture---

Can anyont tell me what I might be doing wrong, I went through al the
steps of the setting up the server, following the directions for the linux
server, but Im still not getting a boot.


Thanks
Bryan