Subject: Re: Processor correctavke error?
To: Jason Thorpe <thorpej@nas.nasa.gov>
From: Michael T. Stolarchuk <mts@rare.net>
List: port-alpha
Date: 06/12/1998 09:48:21
In message <199806112254.PAA09562@lestat.nas.nasa.gov>, Jason Thorpe writes:
> > where's jason's bwx kernel? i'd like to try it. i'm still building
> > out of 1.3.2... is it worthwhile to get a high reve tree...
>
> ftp://ftp.netbsd.org/pub/incoming/thorpej/netbsd-alpha-GENERIC.gz
this is LONG message... sorry... but i wanna include what i got...
First is the show config, describing the processor type, then
there are several boots, the first thorpej boot succeeds, but i noticed
that the cable for the scsi drive isn't connected, so i connected
it and rebooted (warm), and then there's machine checks... so
i tried several times ... without success...
i've included all the output from each of these attempts... that's
why its such a long mail message...
ok jason, i've ftp'ed it... built a bootFloppy, slammed into into
the test alpha...
Its IS the pyxis chipset...
>>>show config
Digital AlphaPC 164LX 533 MHz
SRM Console T4.9-51 VMS PALcode V1.20-1, OSF PALcode V1.22-1
SROM Revision: 3.1.2
Alpha 21164A-2
Pyxis ASIC Pass 2
MEMORY
1024 MBytes of system memory
Bank # Size Base Addr
------ ---------- ---------
0 512 MB 000000000
1 512 MB 020000000
Total Bad Pages = 0
Total Good Memory = 1024 MBytes
Bcache Size = 2 MB
PCI Bus
Bus 00 Slot 05: DE500-BA Network Con
ewa0.0.0.5.0 00-00-F8-1A-44-D8
Bus 00 Slot 08: Intel 82378
Bridge to Bus 1, ISA
Bus 00 Slot 09: DECchip 21050-AA
Bridge to Bus 2, PCI
Bus 00 Slot 11: CMD PCI0646 IDE
pka0.0.0.11.0 PCI EIDE
PCI Bus
PCI Bus
Bus 02 Slot 04: 82789004
Bus 02 Slot 05: 82789004
ISA
Slot Device Name Type Enabled BaseAddr IRQ DMA
0
0 MOUSE Embedded Yes 60 12
1 KBD Embedded Yes 60 1
2 COM1 Embedded Yes 3f8 4
3 COM2 Embedded Yes 2f8 3
4 LPT1 Embedded Yes 3bc 7
5 FLOPPY Embedded Yes 3f0 6 2
>>>
------------------------------------------------------------
boot attempt
------------------------------------------------------------
>>>b dva0p*** keyboard not plugged in...
ff.fe.fd.fc.fb.fa.f9.f8.f7.f6.f5.f3.f2.f1.f0.
ef.ee.ed.probing hose 0, PCI
probing PCI-to-ISA bridge, bus 1
Vector allocation failed for hose 0, bus 0, slot 11, pin 1
Vector 0095 already allocated
bus 0, slot 5 -- ewa -- DE500-BA Network Controller
bus 0, slot 11 -- pka -- CMD PCI0646 IDE
bus 0, slot 11 -- pkb -- CMD PCI0646 IDE
ec.f4.eb.ea.e9.e8.e7.
Digital AlphaPC 164LX 533 MHz Console T4.9-51, Jul 15 1997 11:00:09
>>>b dva0
(boot dva0.0.0.0.0 -flags 0)
block 0 of dva0.0.0.0.0 is a valid boot block
reading 15 blocks from dva0.0.0.0.0
bootstrap code read in
base = 1d8000, image_start = 0, image_bytes = 1e00
initializing HWRPB at 2000
initializing page table at 1ca000
initializing machine state
setting affinity to the primary CPU
jumping to bootstrap code
NetBSD/Alpha Primary Boot
Jumping to entry point...
NetBSD/Alpha Secondary Boot, Revision 1.9
(cjs@bishop, Wed Dec 31 00:52:27 PST 1997)
VMS PAL revision: 0x1000100010114
OSF PAL rev: 0x1000100020116
Switch to OSF PAL code succeeded.
Boot flags: 0
Loading netbsd...
open netbsd: No such file or directory
Loading netbsd.gz...
2386448+245848 [85+273624+164143]
Entering netbsd.gz at 0xfffffc0000300fc0...
Unrecognized boot flag '0'.
consinit: not using prom console
Copyright (c) 1996, 1997, 1998
The NetBSD Foundation, Inc. All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
NetBSD 1.3E (GENERIC) #143: Sat Jun 6 12:59:25 PDT 1998
thorpej@bishop:/tmp_mnt/dracul/u5/netbsd/src/sys/arch/alpha/compile/GENERIC
Digital AlphaPC 164LX 533 MHz, 531MHz
8192 byte page size, 1 processor.
real mem = 1073741824 (1941504 reserved for PROM, 1071800320 used by NetBSD)
avail mem = 937844736
using 13083 buffers containing 107175936 bytes of memory
mainbus0 (root)
cpu0 at mainbus0: ID 0 (primary), 21164A (pass 2)
cia0 at mainbus0: DECchip 2117x Core Logic Chipset (Pyxis), pass 1
cia0: extended capabilities: 111<WLEN,MWEN,BWEN>
cia0: using BWX for PCI config and device access
pci0 at cia0 bus 0
pci0: i/o enabled, memory enabled
de0 at pci0 dev 5 function 0
de0: interrupting at eb164 irq 2
de0: DEC DE500-BA 21143 [10-100Mb/s] pass 3.0
de0: address 00:00:f8:1a:44:d8
de0: enabling 10baseT port
ahc0 at pci0 dev 7 function 0
ahc0: interrupting at eb164 irq 1
ahc0: aic7880 Wide Channel, SCSI Id=7, 16 SCBs
scsibus0 at ahc0 channel 0: 16 targets
ahc0: target 0 using 16Bit transfers
ahc0: target 0 synchronous at 20.0MHz, offset = 0x8
sd0 at scsibus0 targ 0 lun 0: <IBM, DGVS09U, 0350> SCSI3 0/direct fixed
sd0: 8705MB, 7386 cyl, 12 head, 201 sec, 512 bytes/sect x 17829870 sectors
sio0 at pci0 dev 8 function 0: Intel 82378ZB System I/O (SIO) (rev. 0x43)
ahc1 at pci0 dev 9 function 0
ahc1: interrupting at eb164 irq 3
ahc1: aic7880 Wide Channel, SCSI Id=7, 16 SCBs
scsibus1 at ahc1 channel 0: 16 targets
pciide0 at pci0 dev 11 function 0: CMD Technology PCI0646 (rev. 0x01)
pciide0: bus-master DMA support present, but unused (no driver support)
pciide0: primary channel wired to compatibility mode
pciide0: primary channel ignored (not responding; disabled or no drives?)
pciide0: secondary channel wired to compatibility mode
pciide0: secondary channel ignored (not responding; disabled or no drives?)
isa0 at sio0
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
com0: console
com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, working fifo
lpt0 at isa0 port 0x3bc-0x3bf irq 7
------------------------------------------------------------
Failed boot attempt
------------------------------------------------------------
p*** keyboard not plugged in...
ff.fe.fd.fc.fb.fa.f9.f8.f7.f6.f5.f3.f2.f1.f0.
ef.ee.ed.probing hose 0, PCI
probing PCI-to-ISA bridge, bus 1
Vector allocation failed for hose 0, bus 0, slot 11, pin 1
Vector 0095 already allocated
bus 0, slot 5 -- ewa -- DE500-BA Network Controller
bus 0, slot 11 -- pka -- CMD PCI0646 IDE
bus 0, slot 11 -- pkb -- CMD PCI0646 IDE
ec.f4.eb.ea.e9.e8.e7.
Digital AlphaPC 164LX 533 MHz Console T4.9-51, Jul 15 1997 11:00:09
>>>b dva0
(boot dva0.0.0.0.0 -flags 0)
block 0 of dva0.0.0.0.0 is a valid boot block
reading 15 blocks from dva0.0.0.0.0
bootstrap code read in
base = 1d8000, image_start = 0, image_bytes = 1e00
initializing HWRPB at 2000
initializing page table at 1ca000
initializing machine state
setting affinity to the primary CPU
jumping to bootstrap code
NetBSD/Alpha Primary Boot
Jumping to entry point...
NetBSD/Alpha Secondary Boot, Revision 1.9
(cjs@bishop, Wed Dec 31 00:52:27 PST 1997)
VMS PAL revision: 0x1000100010114
OSF PAL rev: 0x1000100020116
Switch to OSF PAL code succeeded.
Boot flags: 0
Loading netbsd...
open netbsd: No such file or directory
Loading netbsd.gz...
2386448+245848 [85+273624+164143]
Entering netbsd.gz at 0xfffffc0000300fc0...
Unrecognized boot flag '0'.
consinit: not using prom console
Copyright (c) 1996, 1997, 1998
The NetBSD Foundation, Inc. All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
NetBSD 1.3E (GENERIC) #143: Sat Jun 6 12:59:25 PDT 1998
thorpej@bishop:/tmp_mnt/dracul/u5/netbsd/src/sys/arch/alpha/compile/GENERIC
Digital AlphaPC 164LX 533 MHz, 531MHz
8192 byte page size, 1 processor.
real mem = 1073741824 (1941504 reserved for PROM, 1071800320 used by NetBSD)
avail mem = 937844736
using 13083 buffers containing 107175936 bytes of memory
mainbus0 (root)
cpu0 at mainbus0: ID 0 (primary), 21164A (pass 2)
cia0 at mainbus0: DECchip 2117x Core Logic Chipset (Pyxis), pass 1
cia0: extended capabilities: 111<WLEN,MWEN,BWEN>
cia0: using BWX for PCI config and device access
pci0 at cia0 bus 0
pci0: i/o enabled, memory enabled
de0 at pci0 dev 5 function 0
de0: interrupting at eb164 irq 2
de0: DEC DE500-BA 21143 [10-100Mb/s] pass 3.0
de0: address 00:00:f8:1a:44:d8
de0: enabling 10baseT port
ahc0 at pci0 dev 7 function 0
ahc0: interrupting at eb164 irq 1
ahc0: aic7880 Wide Channel, SCSI Id=7, 16 SCBs
scsibus0 at ahc0 channel 0: 16 targets
ahc0: target 0 using 16Bit transfers
ahc0: target 0 synchronous at 20.0MHz, offset = 0x8
sd0 at scsibus0 targ 0 lun 0: <IBM, DGVS09U, 0350> SCSI3 0/direct fixed
sd0: 8705MB, 7386 cyl, 12 head, 201 sec, 512 bytes/sect x 17829870 sectors
sio0 at pci0 dev 8 function 0: Intel 82378ZB System I/O (SIO) (rev. 0x43)
ahc1 at pci0 dev 9 function 0
unexpected machine check:
mces = 0x1
vector = 0x670
param = 0xfffffc0000006068
pc = 0xfffffc00004aeed4
ra = 0xfffffc00004aeecc
curproc = 0xfffffc0000563050
pid = 0, comm =
panic: machine check
halted.
------------------------------------------------------------
two more of the very same, left out.
mts.
------------------------------------------------------------