--ikeVEW9yuYc//A+q
Content-Type: text/plain; charset=us-ascii
Content-Disposition: inline
Content-Transfer-Encoding: quoted-printable

On Sat, Mar 15, 2003 at 09:15:44AM +0000, Gavan Fantom wrote:
> On Sat, 15 Mar 2003, Frank Wennmohs wrote:
>=20
> > Yesterday I tried to install the 1.6.1_RC2 on my RiscPC
> > but during the install of a completely new system the
> > install system something got seriously wrong....:
> >
> > After installing the sets from 200303140000
> > and then after unpacking those the system died when trying
> > to access the hard disc again.
> > A restart and trying to mount the partitions by hand
> > showed the the discs inodes etc. were totally screwed up!!!
> >
> > Can anyone verify this?
> >
> > I did this on a hard disc on which I installed versions of
> > NetBSD a dozen times without any problems, so I don't think
> > that the hardware is damaged.
>=20
> I didn't have any problems with an earlier build of RC2.. what hardware
> are you running on?
>=20
> I'm using the plain old internal IDE interface.
>=20

Yes, I am also using quite a plain system:
RPC700 board, internal IDE, SA110, 64MB

> Is the problem repeatable? What happens if you restart the installation
> from scratch?
>=20

The whole installation was from scratch.
I just did an installation of 1.6O (200302240000)
and the problem does not occur.

Any suggestions?


Frank




--ikeVEW9yuYc//A+q
Content-Type: application/pgp-signature
Content-Disposition: inline

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.1 (FreeBSD)

iD8DBQE+cxmYQVAohVxat4gRApRvAJ9JLe/Y8SWVToRMQG2XgUe9dQkK7gCfYKER
6TWbf2hnDGnZK33wiOZKr0k=
=e72P
-----END PGP SIGNATURE-----

--ikeVEW9yuYc//A+q--