When I plug in a usb flash drive that I have, I get the following:

umass0 at uhub1 port 1 configuration 1 interface 0
umass0: GENERIC USB FLASH DISK, rev
1.10/2.01, addr 2
umass0: using SCSI over BBB-P
scsibus0 at umass0: 2 targets, 1 luns per
target
scsibus0: waiting 2 seconds for devices to
settle...
scsibus0 target 1 lun 0: <GENERIC, USB
FLASH DISK, CCCC> SCSI0 0/direct removable not configured

I believe the drive is supposed to come up as sd0. But, I get no messages
re sd0 and I certainly cannot mount it. I get a "Device not configured"
error whenever I try to mount any of the sd0[a|b|c|d].

So, did I leave something out of my kernel?

namaste,
Mark