On Sun, Jan 06, 2002 at 01:05:24PM +0000, Carl Libra wrote:
> The restart of rhe syslog didn't work so I added it to the messages. Here 
> the output.
> 
> Jan  6 15:27:25 testje reboot: rebooted by root
> Jan  6 15:27:25 testje syslogd: exiting on signal 15
> Jan  6 15:28:28 testje syslogd: restart
> Jan  6 15:28:29 testje savecore: no core dump
> Jan  6 15:29:32 testje pptp[214]: log[main:pptp.c:74]: using remote IP 
> address 10.0.0.138
> Jan  6 15:29:32 testje pptp[216]: log[pptp_conn_open:pptp_ctrl.c:162]: 
> sending start ctrl conn rqst
> Jan  6 15:29:32 testje pptp[216]: 
> log[pptp_dispatch_ctrl_packet:pptp_ctrl.c:535]: received start conn reply: 
> v256 rcode 1 ecode 0 fcap 3 bcap 3 chans 32 fw 1 host `ADNT' vendor 
> `ALCATEL'
> Jan  6 15:29:32 testje pptp[216]: 
> log[pptp_dispatch_ctrl_packet:pptp_ctrl.c:558]: Client connection 
> established.
> Jan  6 15:29:33 testje pptp[216]: log[pptp_call_open:pptp_ctrl.c:215]: 
> sending out call rqst
> Jan  6 15:29:33 testje pptp[216]: 
> log[pptp_dispatch_ctrl_packet:pptp_ctrl.c:689]: received out call reply: id 
> 0 peer 0 result 1 err 0 cause 0 speed 8388608 rsize 8 delay 0 channel 0
> Jan  6 15:29:33 testje pptp[216]: 
> log[pptp_dispatch_ctrl_packet:pptp_ctrl.c:715]: Outgoing call established: 
> cid 0 @ 8388608 bps.
> Jan  6 15:29:34 testje pppd[218]: pppd 2.4.0 started by root, uid 0
> Jan  6 15:29:34 testje pppd[218]: Using interface ppp0
> Jan  6 15:29:34 testje pppd[218]: Connect: ppp0 <--> /dev/ttyp0
> Jan  6 15:30:04 testje pppd[218]: LCP: timeout sending Config-Requests
> Jan  6 15:30:04 testje pppd[218]: Connection terminated.
> Jan  6 15:30:05 testje pppd[218]: Exit.

Can you look on the wire with tcpdump at this point, to see whar happens to
the config-requests ?

Note I'm not a pptp specialist, I never used it myself.

--
Manuel Bouyer, LIP6, Universite Paris VI.           Manuel.Bouyer@lip6.fr
--