On Fri, Jul 27, 2001 at 09:39:22AM -0400, jjohns wrote:
> Hi Manuel:
> Sorry to bother you - yet again- and you'll have to pardon my ignorance.. however, I have a
> question...
> 
> At what point do you run the disklabel -i ld0 command to change the geometry?? I tried it - went
> through to the partition point - exited from sysinst and changed it.. then when I ran the
> sysinst again - I got the same error. I guess my real question is - once you make the change to
> the geometry - how do you get back into the sysinst to continue with the install - or is there
> another procedure that I need to follow after this?

Exit from sysinst after partitionning your disk. Run disklabel -i ld0 and
change geometry at this point. Then restart sysinst and choose 'custon
partitioning' and accept the default values.

BTW, by how much did you change your sec per cyl ? maybe it's still too big ?

--
Manuel Bouyer, LIP6, Universite Paris VI.           Manuel.Bouyer@lip6.fr
--