Subject: detecting a WaveLAN
To: None <netbsd-help@netbsd.org>
From: Brook Milligan <brook@biology.nmsu.edu>
List: netbsd-help
Date: 02/15/2001 21:25:30
I am trying to get my system to detect a WaveLAN card with no luck.
Things I have tried include the following:

- wi device in kernel

- kernel with and without the following:

	options PCIC_ISA_ALLOC_IOBASE=0x300
	options PCIC_ISA_ALLOC_IOSIZE=0x0ff

- with and without setting the BIOS to allocate IRQs 9, 10, 15 to ISA

The WaveLAN care is never detected.  I am new to PCMCIA issues, so I'm
not sure what to do.  On another (older) machine the initial symptom
was that the wi driver complained about not reading the MAC address;
switching to the 0x300 IO range immediately fixed it though.

If it helps, below is the boot probe output.

Any help is greatly appreciated.  Thank you very much.

Cheers,
Brook

===========================================================================

NetBSD 1.5 (LARIX) #2: Thu Feb 15 20:31:17 MST 2001
cpu0: Intel Pentium III (686-class)
total memory = 127 MB
avail memory = 113 MB
using 1659 buffers containing 6636 KB of memory
BIOS32 rev. 0 found at 0xf06b0
mainbus0 (root)
pci0 at mainbus0 bus 0: configuration mode 1
pci0: i/o space, memory space enabled
pchb0 at pci0 dev 0 function 0
pchb0: Intel 82443BX Host Bridge/Controller (rev. 0x03)
ppb0 at pci0 dev 1 function 0: Intel 82443BX AGP Interface (rev. 0x03)
pci1 at ppb0 bus 1
pci1: i/o space, memory space enabled
vga1 at pci1 dev 0 function 0: Matrox MGA G400 AGP (rev. 0x03)
wsdisplay0 at vga1: console (80x25, vt100 emulation)
pcib0 at pci0 dev 4 function 0
pcib0: Intel 82371AB PCI-to-ISA Bridge (PIIX4) (rev. 0x02)
pciide0 at pci0 dev 4 function 1: Intel 82371AB IDE controller (PIIX4) (rev. 0x01)
pciide0: bus-master DMA support present
pciide0: primary channel wired to compatibility mode
wd0 at pciide0 channel 0 drive 0: <ST34310A>
wd0: drive supports 16-sector pio transfers, lba addressing
wd0: 4111 MB, 8354 cyl, 16 head, 63 sec, 512 bytes/sect x 8420832 sectors
wd0: 32-bit data port
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 2
pciide0: primary channel interrupting at irq 14
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2 (using DMA data transfers)
pciide0: secondary channel wired to compatibility mode
pciide0: disabling secondary channel (no drives)
uhci0 at pci0 dev 4 function 2: Intel 82371AB USB Host Controller (PIIX4) (rev. 0x01)
pci_intr_map: no mapping for pin D
uhci0: couldn't map interrupt
Intel 82371AB Power Management Controller (PIIX4) (miscellaneous bridge, revision 0x02) at pci0 dev 4 function 3 not configured
siop0 at pci0 dev 10 function 0: Symbios Logic 53c810a (fast scsi)
siop0: interrupting at irq 5
scsibus0 at siop0: 8 targets, 8 luns per target
isa0 at pcib0
ep0 at isa0 port 0x300-0x30f irq 10: 3Com 3C509 Ethernet
ep0: address 00:a0:24:00:ed:c4, 8KB byte-wide FIFO, 1:1 Rx:Tx split
ep0: 10baseT, 10base5, 10base2 (default 10base2)
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, working fifo
pckbc0 at isa0 port 0x60-0x64
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pmsi0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pmsi0 mux 0
lpt0 at isa0 port 0x378-0x37b irq 7
pcppi0 at isa0 port 0x61
midi0 at pcppi0: PC speaker
sysbeep0 at pcppi0
isapnp0 at isa0 port 0x279: ISA Plug 'n Play device support
npx0 at isa0 port 0xf0-0xff: using exception 16
fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB, 80 cyl, 2 head, 18 sec
pcic1 at isa0 port 0x3e2-0x3e3 iomem 0xe0000-0xe3fff
pcic1: controller 0 (Intel 82365SL Revision 1) has sockets A and B
pcic1: controller 1 (Intel 82365SL Revision 1) has no sockets
pcmcia0 at pcic1 controller 0 socket 0
pcmcia1 at pcic1 controller 0 socket 1
isapnp0: no ISA Plug 'n Play devices found
apm0 at mainbus0: Power Management spec V1.2 (BIOS mgmt disabled)
APM power mgmt engage (device 1): power management disabled (0x10f)
biomask eb65 netmask ef65 ttymask ffe7
scsibus0: waiting 2 seconds for devices to settle...
cd0 at scsibus0 target 5 lun 0: <PLEXTOR, CD-ROM PX-8XCS, 1.03> SCSI2 5/cdrom removable
pcic1: controller 0 detecting irqs with mask 0xdeb8:..9..15
pcic1: using irq 9 for socket events
boot device: wd0
root on wd0a dumps on wd0b
root file system type: ffs