Jeff Northon wrote:

> > iy0     at isa? port 0x360 irq ?                # EtherExpress PRO 10 ISA
>                        ^^^^^^
> Is it possible to configure the ISA card to a different port than what is
> hardwired in the config?

  Yes, but it's very ugly: you can boot into the debugger using "boot
-d", then change the corresponding entry in the locator table (starting
at the "loc" symbol IIRC).

> Is there a software config utility that tells where the card is
> configured to?

  Most ISA NICs come with DOS utilities for doing that.  You can try
downloading that, write it onto a floppy, boot into DOS, and start it
from there (FreeDOS might be an alternative here, if you don't have
MS-DOS).

  Cheers
      ,
   Rene