Hello all.

I tried to follow the steps as described in the "How to use a ZIP
disk"-section at the "Other FAQs and HOWTOs"-page. The disklabel of my
zip is included below. Mounting the 'e'-partition of this zip fails with
an "Invalid argument" error message. The zip is configured as follows:

wd1 at pciide0 channel 1 drive 1: <IOMEGA ZIP 100>

Any help is greatly appreciated.


# /dev/rwd1d:
type: ESDI
disk: IOMEGA  ZIP 100 
label: fictitious
flags:
bytes/sector: 512
sectors/track: 32
tracks/cylinder: 12
sectors/cylinder: 384
cylinders: 512
total sectors: 536870911
rpm: 3600
interleave: 1
trackskew: 0
cylinderskew: 0
headswitch: 0           # microseconds
track-to-track seek: 0  # microseconds
drivedata: 0 

8 partitions:
#        size   offset     fstype   [fsize bsize   cpg]
  d: 536870911        0     unused        0     0         # (Cyl.    0 -
1398101
*)
  e:   196192       32      MSDOS                        # (Cyl.    0*-
510)
disklabel: boot block size 0
disklabel: super block size 0

Regards,



-- 
Audun Nordal