The following reply was made to PR kern/34184; it has been noted by GNATS.

From: Chris Billington <cbillington@emulti.net>
To: gnats-bugs@netbsd.org
Cc: 
Subject: re: kern/34184
Date: Wed, 16 Aug 2006 13:19:44 +0800

 Dmesg obtained with boot -cv and transcribed
 
 NetBSD 3.0_STABLE
 
 pci0 at mainbus 0 : configuration mode 1
 pci0: i/o space, memory space enabled, rd/line, rd/mult,wr/inv ok
 pchb0 at pci0 dev 0 function 0
 pchb0: Intel 82915PM/GM/GMS, 82910 GML Host Bridge (rev. 0x03)
 pchb0: random number generator enabled
 agp0 at pchb0: unknown memory configuration, disabling
 vga1 at pci0 dev 2 function 0: Intel 82915 GM/GMS Integrated Graphics 
 Device (Rev. 0x03)
 wsdisplay at vga1 kbdmux 1: console (80x25, vt100 emulation)
 wsmux1: connecting to wsdisplay0
 Intel 82915GM/GMS IGD Companion (Miscellaneous display, revision 0x03) 
 at pci0 dev 2 function 1 not configured
 uchi0 at pci0....
 <usb uhci 1-4 messages>
 ...
 ehci0 at pci0 dev 29 function 7: intel 82801FB/FR USB EHCI controller 
 (Rev 0x04)
 ehci0: interrupting at irq3
 <hangs here>
 
 Notes:
 - if ehci? at pci? is disabled in autoconf, the system hangs further on 
 with a Page Fault in swapper, just after the cbb0 device is configured.
 - if cbb0 is disabled, then it hangs at isapnp0 at isa0...
 - With NetBSD-3.0-release the next message after the ehci interrupting 
 at irq3 is 'BIOS has given up interrupt', then boot continues normally.
 
 Happy to help with futher debugging if required.
 Chris