Re: Problems with IPMI and wm? sharing a physical Ethernet port

[Masanobu SAITOH <msaitoh%execsw.org@localhost>]

Hello, all.

(2012/06/27 4:18), Jarle Greipsland wrote:
> Manuel Bouyer <bouyer%antioche.eu.org@localhost> writes:
> > On Tue, Jun 26, 2012 at 07:29:12PM +0200, Jarle Greipsland wrote:
> > > > Do you have some media settings in ifconfig.wm0 ?
> > > media autoselect
> >
> > Maybe try to remove the media settings completely
> I tried that.  It made no difference.
>
>                                 -jarle

 This tread started 365days ago!

 Two days ago, I fixed some bugs about BMC (if_wm.c rev. 1.260).

 Today I tested with Supermicro X7SPA-HF. This is the same
product that the first mail reported. I connected only one
Ethernet port "LAN1" to a switch. This port is shared with BMC.
The LAN1 port (wm0) works fine.

And:

 -current: BMC still respond after booted NetBSD.

 6.1:      Same as above.

 6.0:      BMC doesn't respond after booted NetBSD.

I don't know when I fixed the bug :)


The following log was made when netbsd was up.
192.168.0.250 is not wm0's address but the BMC's address.

> gt110a: {175} ipmitool -I lan -H 192.168.0.250 mc info
> Device ID                 : 32
> Device Revision           : 1
> Firmware Revision         : 2.66
> IPMI Version              : 2.0
> Manufacturer ID           : 47488
> Manufacturer Name         : Unknown (0xB980)
> Product ID                : 2566 (0x0a06)
> Product Name              : Unknown (0xA06)
> Device Available          : yes
> Provides Device SDRs      : no
> Additional Device Support :
>     Sensor Device
>     SDR Repository Device
>     SEL Device
>     FRU Inventory Device
>     IPMB Event Receiver
>     IPMB Event Generator
>     Chassis Device
> Aux Firmware Rev Info     :
>     0x00
>     0x00
>     0x00
>     0x00
> gt110a: {176} ipmitool -I lan -H 192.168.0.250 sdr
> System Temp      | 37 degrees C      | ok
> CPU Temp         | 35 degrees C      | ok
> CPU FAN          | disabled          | ns
> SYS FAN          | 1510 RPM          | ok
> CPU Vcore        | 1.16 Volts        | ok
> Vichcore         | 1.04 Volts        | ok
> +3.3VCC          | 3.28 Volts        | ok
> VDIMM            | 1.83 Volts        | ok
> +5 V             | 5.02 Volts        | ok
> +12 V            | 11.78 Volts       | ok
> +3.3VSB          | 3.28 Volts        | ok
> VBAT             | 2.93 Volts        | ok
> Chassis Intru    | 0 unspecified     | nc
> PS Status        | 0 unspecified     | nc


--
-----------------------------------------------
                SAITOH Masanobu (msaitoh%execsw.org@localhost
                                 msaitoh%netbsd.org@localhost)