Re: Can't boot -curent in qemu

[Christoph Egger <Christoph_Egger%gmx.de@localhost>]

On 14.04.12 04:19, Paul Goyette wrote:
> I just did a 'build.sh release' and I'm trying to install/boot via qemu.
> After the kernel loads, it starts to auto-configure, and then I get
> 
> ...
> pci0 at mainbus0 bus 0: configuration mode 1
> pchb0 at pci0 dev 0 function 0: vendor 0x8086 product 0x1237 (rev. 0x02)
> panic: kernel diagnostic assertion "!ifattr ||
> cfdriver_get_iattr(parent->dv_cfdriver, ifattr)" failed: file
> "/build/netbsd-local/src/sys/kern/subr_autoconf.c", line 945
> fatal breakpoint trap in supervisor mode
> trap type 1 code 0 rip ffffffff802545f5 cs 8 rflags 246 cr2  0 cpl 8 rsp
> ffffffff8134f830
> Stopped in pid 0.1 (system) at  ffffffff802545f5:       leave
> 
> 
> Does this look at all familiar to anyone?
> 
> This is a GENERIC kernel built from sources that were updated about 30
> minutes ago...

Yes, that is caused by my last commit that replaces amdtempbus with
amdnb_miscbus. njoly@ pointed to me pci/pchb.c where amdtempbus was
also used. I wasn't aware of that at all.

I am tempted to revert rev 1.32 of pci/pchb.c. But I want to test
that on monday before I commit.

Christoph