Sure.  This is after I added bits in pciide.c to make it accept the
controller, just like with the TX2plus SATA controller.

pciide1 at pci0 dev 15 function 0: Promise Serial ATA/150 TX4 Controller (rev. 0x02)
pciide1: bus-master DMA support present
pciide1: primary channel configured to compatibility mode
pciide1: primary channel ignored (disabled)
pciide1: secondary channel configured to compatibility mode
pciide1: secondary channel ignored (disabled)

BTW, the TX2Plus I just bought isn't using the same PCI ID as the one
in cvs:

Promise Technology product 0x3375 (miscellaneous mass storage, revision 0x02) at pci0 dev 16 function 0 not configured

product PROMISE SATA150TX2PLUS 0x3376 Serial ATA/150 TX2plus Bus Master IDE Accelerator

--Michael

Manuel Bouyer <bouyer@antioche.eu.org> writes:

> On Fri, Apr 11, 2003 at 10:21:20AM -0000, explorer@flame.org wrote:
> > Anyone have any suggestions on getting this critter working?  It complains
> > that both primary and secondary channels are in compatibility mode,
> > then that both are disabled.
> > 
> > I plugged in a "real" IDE disk and will install on that, just as soon as
> > I have a CD image that will actually let me install (the -current
> > stuff runs out of inodes in the mfs /dev ...)
> > 
> > I'm building that ISO now, so I hope to know more this weekend when I can
> > test it again.
> 
> Can you send the dmesg lines about the pciide ?
> 
> -- 
> Manuel Bouyer <bouyer@antioche.eu.org>
>      NetBSD: 24 ans d'experience feront toujours la difference
> --