I've picked up a Fuji FinePix 50i digital camera which comes with
	a USB cradle and identifies itself as a umass device, but it
	doesn't	seem to quite work - it reports 'sd0: drive offline'.
	There is already a quirk listed for it in umass_quirks.c

	Has anyone had any luck with this or a similar camera, or
	have any ideas on how I can collect more information?

	This is under 1.6_BETA5 on i386.

uhci0: interrupting at irq 10
usb0 at uhci0: USB revision 1.0
uhub0 at usb0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
[...]
uhidev0 at uhub0 port 1 configuration 1 interface 0
uhidev0: ARROW STRONG USB Mouse, rev 1.00/0.10, addr 2, iclass 3/1
ums0 at uhidev0: 5 buttons and Z dir.
wsmouse0 at ums0 mux 0
[...]
umass0 at uhub0 port 2 configuration 1 interface 0
umass0: Fuji Photo Film USB Mass Storage, rev 1.10/10.00, addr 3
umass0: using ATAPI over CBI
atapibus1 at umass0 channel 0: 2 targets
sd0 at atapibus1 drive 0: <FUJIFILM, USB-DRIVEUNIT, 1.00> type 0 direct removable
sd0(umass0:0:0): generic HBA error
sd0: drive offline

	detach and reattach repeats:

umass0: at uhub0 port 2 (addr 3) disconnected
sd0 detached
atapibus1 detached
umass0 detached
umass0 at uhub0 port 2 configuration 1 interface 0
umass0: Fuji Photo Film USB Mass Storage, rev 1.10/10.00, addr 3
umass0: using ATAPI over CBI
atapibus1 at umass0 channel 0: 2 targets
sd0 at atapibus1 drive 0: <FUJIFILM, USB-DRIVEUNIT, 1.00> type 0 direct
removable
sd0(umass0:0:0): generic HBA error
sd0: drive offline

	usbdevs reports:

Controller /dev/usb0:
addr 1: full speed, self powered, config 1, UHCI root hub(0x0000), Intel(0x8086), rev 1.00
 port 1 addr 2: low speed, power 40 mA, config 1, USB Mouse(0x0001), ARROW STRONG(0x0ab0), rev 0.10
 port 2 addr 3: full speed, self powered, config 1, USB Mass
Storage(0x0100), Fuji Photo Film(0x04cb), rev 10.00