This is a CIS dump (done from linux) of the same card.. I don't know enough
low-level stuff to be able to tell whether its useful or not, maybe one of
you guys can figure it out?

Also, I was reading up about the card on the web, and the "Rev. D1", from
what I've read, has a totally different chipset/configuration. I'm out of
ideas.

the dump:

Tuple #1, code = 0x1 (Common memory descriptor), length = 3
    000:  d1 3a ff
        Common memory device information:
                Device number 1, type Function specific, WPS = OFF
                Speed = 250nS, Memory block size = 8Kb, 8 units
Tuple #2, code = 0x1c (Other conditions for common memory), length = 4
    000:  01 d1 3a ff
        (MWAIT)
Tuple #3, code = 0x17 (Attribute memory descriptor), length = 3
    000:  41 00 ff
        Attribute memory device information:
                Device number 1, type EEPROM, WPS = OFF
                Speed = 250nS, Memory block size = 512b, 1 units
Tuple #4, code = 0x20 (Manufacturer ID), length = 4
    000:  49 01 30 02
        PCMCIA ID = 0x149, OEM ID = 0x230
Tuple #5, code = 0x21 (Functional ID), length = 2
    000:  06 01
        Network/LAN adapter - POST initialize
Tuple #6, code = 0x15 (Version 1 info), length = 40
    000:  04 01 44 2d 4c 69 6e 6b 00 44 46 45 2d 36 35 30
    010:  00 46 61 73 74 20 45 74 68 65 72 6e 65 74 00 52
    020:  65 76 2e 20 44 31 00 ff
        Version = 4.1, Manuf = [D-Link], card vers = [DFE-650]
        Addit. info = [Fast Ethernet],[Rev. D1]
Tuple #7, code = 0x1a (Configuration map), length = 5
    000:  01 20 00 04 0b
        Reg len = 2, config register addr = 0x400, last config = 0x20
        Registers: XX-X----
Tuple #8, code = 0x1b (Configuration entry), length = 7
    000:  e0 81 18 45 30 fc be
        Config index = 0x20(default)
        Interface byte = 0x81 (I/O)  wait signal supported
        Card decodes 5 address lines, limited 8/16 Bit I/O
                IRQ modes: Level
                IRQs:  2 3 4 5 6 7 9 10 11 12 13 15
Tuple #9, code = 0x14 (No link), length = 0
Tuple #10, code = 0xff (Terminator), length = 0


--Sean