On Thu, Jun 15, 2000 at 05:35:52PM +0200, Manuel Bouyer wrote:

 > Hum, ok so this board is based on a wide chip but only the narrow connector
 > is used. Sure, with a wide disk the driver will negotiate wide transfers
 > and try to use them; there's no fall-back mechanism (hum depending on how
 > things are setup I'm not sure transfers will fail, they may just transfer
 > incorrect data with highter bits all 0 or all 1). I'm not sure how to handle
 > this; this is a quite unusual setup.

...probably read the EEPROM on the card to see what's there.

-- 
        -- Jason R. Thorpe <thorpej@zembu.com>