I'm at wits ends again.
	Someone clued me in on a couple things the last time I had this
question, and they were dead on when they said cabling problem, but now I'm
past that, and I still can't get this tape changer to work.
	If I do a chio or mt to do something to the changer or the tape, it
locks up.
	It identifies on boot as:

Oct 15 10:39:40 meta /netbsd: scsibus0 at aic0: 8 targets
Oct 15 10:39:40 meta /netbsd: st0 at scsibus0 targ 0 lun 0: <ARCHIVE, Python 28849-XXX, 4.CM> SCSI2 1/sequential removable
Oct 15 10:39:40 meta /netbsd: st0: density code 0x13, 512-byte blocks, write-enabled
Oct 15 10:39:41 meta /netbsd: ch0 at scsibus0 targ 0 lun 1: <ARCHIVE, Python 28849-XXX, 4.CM> SCSI2 8/changer removable
Oct 15 10:39:41 meta /netbsd: ch0: 0 slots, 1 drive, 1 picker, 0 portals
Oct 15 10:39:41 meta /netbsd: wdc0 at isa0 port 0x1f0-0x1f7 irq 14

	I'm running 1.2G, not -current, so if there are changes I should
have tracked, please let me know.
	Anyone have any suggestions?
	-- Ricky

---
'94 ST1100 'Turvy' 					luwenth@netscum.com
		That which does not kill me makes me stranger.